User manual RYOBI 285-1

[. . . ] Es imprescindible que lea las instrucciones de este manual antes del montaje y de la puesta en servicio. Prima di procedere al montaggio e alla messa in funzione, indispensabile leggere attentamente le istruzioni del presente manuale. indispensvel ler as instrues deste manual antes de montar e pr em servio. Het is absoluut noodzakelijk vr montage en inbedrijfstelling de aanwijzingen in deze handleiding te lezen. [. . . ] If changing cutters, cutter will easily slip from collet (24) after loosening collet nut. For example: The collet is machined to precision tolerances to fit cutters with 1/2" (12. 7 mm) diameter shanks. To use cutters with 1/4" (6. 35 mm) diameter shanks, insert the 1/4" (6. 35 mm) collet adaptor(18) into the 1/2" (12. 7 mm) collet. Insert shank of cutter until shank bottoms out, then pull it out 1/16" (1. 6 mm) to allow for expansion when the bit gets hot. Tighten the collet nut securely by turning clockwise with the wrench provided. WARNING If the collet nut is not securely tightened, the cutter may detach during use causing serious personal injury. WARNING Do not use cutters with undersized shanks. Undersized shanks will not tighten properly and could be thrown from the tool causing injury. 15 Loosen the stop bar (9). Unlock (U) the plunge lock lever (14) by turning it counter clockwise. Lower the router body until the cutter is in contact with the work-piece. 13) ZERO RESET INDICATOR The zero reset indicator allows you to use the scale provided on the housing to make quick depth of cut changes to existing depth of cut settings. Simply choose a reference point on the scale and slide the zero reset indicator up or down the scale the distance required for new depth of cut. Then change stop bar position by loosening lock knob and adjusting stop bar until red line on zero reset indicator moves back to reference point. Tighten lock knob securely to lock stop bar in new position. The cutter position will now increase or decrease the exact distance the stop bar was adjusted. Note: Each mark on the inch scale indicates 1/16 in. When routing across the face of boards, set router at desired depth of cut, place the edge of router base against workpiece, and turn on the router. Slowly feed the cutter into the workpiece along desired line of cut. WARNING If desired depth of cut is greater than can be safely cut in one pass, make cuts in two or more passes. When routing straight cuts across stock, clamp a straight edge to the workpiece to use as a guide. Position the straightedge parallel to the line of cut and offset the distance between the cutting edge of the cutter and the edge of the router base. [. . . ] , , , Ryobi. . RO GARANIE - CONDIII Acest produs Ryobi este garantat n cazul viciilor de fabricaie i pieselor cu defecte pentru o durat de douzeciipatru (24) de luni, ncepnd cu data facturii originale emis de ctre comerciant utilizatorului final. Deteriorrile provocate prin uzur normal, printr-o utilizare sau ntreinere anormal sau neautorizat, sau prin forarea utilajului sunt excluse din prezenta garanie acestea aplicndu-se i accesoriilor ca baterii, becuri, lame, capete, saci, etc. n caz de funcionare defectuoas n perioada de garanie, v rugm s trimitei produsul NEDEMONTAT mpreun cu factura de cumprare furnizorului dumneavoastr sau la Centrul Service Agreat Ryobi cel mai apropiat de dumneavoastr. [. . . ]