User manual RYOBI 310BVR-SERIALS-304122405-THRU-611000000

[. . . ] Es imprescindible que usted lea las instrucciones contenidas en este manual antes de montar y poner en marcha la sierra. Prima di procedere al montaggio e alla messa in funzione della sega, indispensabile leggere attentamente le istruzioni del presente manuale. indispensvel ler as instrues deste manual antes de montar e pr em servio. Het is absoluut noodzakelijk vr montage en inbedrijfstelling de aanwijzingen in deze handleiding te lezen. [. . . ] There may be a sound signal lasting 12 to 15 seconds longer than usual (even if the sawblade is already stopped). 6. 4 6. 5 7. 7. 1 7. 2 7. 3 7. 4 7. 5 7. 6 7. 7 RECOMMENDATIONS PRIOR TO USING THE SAW Always disconnect the power plug before any maintenance operation or adjustment. Before start-up, make sure that the sawblade is properly fixed and operating correctly. The table saw must be earthed in compliance with applicable standards. Damaged cables and plugs must be replaced immediately by an electrician. The various safety devices must not be removed. All damaged parts/systems must be replaced immediately with genuine spare parts/systems. Never use rapid-cut stainless steel sawblades (HSS). 11 GB 7. 8 7. 9 7. 10 Any cracked or deformed sawblade must be replaced immediately. Workpieces with a tendency to tip or twist must be handled with due care. When the distance between the sawblade and the rip guide is less than 120 mm, you must use a push stick to move the workpiece through the machine. Do not use the machine without a riving knife or an anti-kickback device. Never slow down the sawblade by exerting side pressure. If the size of the sawblade has been reduced through sharpening, or if a smaller blade has been mounted, (min. 315 mm), you must loosen the central screw (Fig. 1) using an SW8 socket wrench, turning clockwise. You can then easily slide the riving knife to adjust it to the new diameter. When the appropriate distance is set (min. 8 mm on a tangential axis in relation to the blade), carefully tighten the central screw (Fig. You must loosen the two hexagonal screws (Fig. 10 box wrench to adjust the height of the riving knife. Here the sliding allows a tangential movement. Once the adjustments have been made, carefully tighten both hexagonal screws (Fig. 2). 11. ADJUSTING THE HEIGHT OF THE SAWBLADE (Fig. [. . . ] Set the blade cutting height so that it is 10 to 15 mm above the piece to be cut. Now set the rip guide to the desired width and tighten it down carefully. The blade protection system must be set according to the thickness of the piece to be cut. Place the workpiece against the rip guide; during the cutting process, guide it with your left hand while pushing with your right hand. 13 GB 16. 2 Cross cut CAUTION! [. . . ]