User manual RYOBI 4060310

[. . . ] Refer to them frequently and use them to instruct other users. If you loan someone this product, also loan these instructions. READ ALL INSTRUCTIONS KNOW YOUR ACCESSORY. [. . . ] Always wear eye protection which is marked to comply with ANSI Z87. 1. SAVE THESE INSTRUCTIONS 2 UNPACKING INFORMATION Remove the loose parts from the box. Make sure that all items listed in the loose parts list are included . Inspect all parts carefully to make sure no breakage or damage occurred during shipping. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. WARNING: If any parts are missing, replace the missing parts before assembling the kit. Failure to do so could result in serious personal injury. LOOSE PARTS LIST 1. 1/4-20 Hex Nuts (2) MITER SLOT TABLE 1/4-20 x 1 in. HEX CAP SCREW WASHER SHIM 1/4-20 HEX NUT Fig. 2 ASSEMBLY WARNING: The table saw should never be connected to a power supply while you are assembling parts. Disconnecting the table saw will prevent accidental starting that could cause serious personal injury. INSTALLING THE MITER SLOT TABLE See Figure 3. Turn the ON/OFF switch to the OFF position. Unplug the saw from the switched on-board outlet. Disconnect the saw from the power supply. Remove the sliding miter table and accessory table from the saw. Place the miter slot table onto the saw as shown in Figure 3. MITER SLOT TABLE 1/4-20 x 1 in. [. . . ] NOTE: The miter slot table must not be higher than the saw table. 1/4-20 x 1 in. HEX CAP SCREW WASHER SHIM 1/4-20 NUT Fig. [. . . ]