User manual RYOBI 410R-SERIALS-111061051-THRU-304012476

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. [. . . ] This will help prevent them from catching or snagging during normal operation. Remove the knobs and mounting bolts and reinstall them through either the top or bottom holes in the handlebar assembly (Fig. Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture. As little as 1% water in the fuel can make fuel and oil separate. When using alcohol-blended fuel, use fresh fuel (less than 60 days old). If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions: · Always use the fresh fuel mix explained in your operator's manual · Always agitate the fuel mix before fueling the unit · Drain the tank and run the engine dry before storing the unit Always stop the engine and allow it to cool before filling the fuel tank. Keep sparks and open flames at a distance from the area. WARNING: Remove fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely in place. The engine does not start, go back to step 3. The engine starts to run, go to the next step. The outside temperature or engine temperature Exceeds 90º F and the engine fails to start after 5 pulls, fully squeeze the throttle control and pull the starter rope briskly 3 to 8 more times. The engine should start within these pulls. NOTE: When starting, the EZ-StartTM Lever will automatically click off when you squeeze the throttle control. Push or pull the unit to the next location. These procedures should also be a part of any seasonal tune-up. NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to any non-road engine repair establishment, individual or authorized service dealer. WARNING: To prevent serious injury, never perform maintenance or repairs with unit running. FREQUENCY Before starting engine Every 10 hours Every 25 hours Every 50 hours NOTE: Maintenance, replacement, or repair of the emission control devices and system may be performed by any non-road engine repair establishment, individual or authorized service dealer. [. . . ] In order to file a claim, go to your nearest Authorized Ryobi Service Center. Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer · The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. The limited warranty set forth below is given by MTD LLC ("MTD") with respect with new merchandise purchased and used in the United States, its possessions and territories. [. . . ]