User manual RYOBI 41CR280G034-41DR280G034

[. . . ] Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. Learn its applications and limitations as well as the specific potential hazards related to this tool. G U A R D A G A I N S T E L E C T R I C A L S H O C K B Y PREVENTING BODY CONTACT WITH GROUNDED SURFACES. [. . . ] Form a habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. Normal sparking of the motor could ignite fumes. KEEP HANDLES DRY, CLEAN AND FREE FROM OIL AND GREASE. Never use brake fluids, gasoline, petroleum based products, or any strong solvents to clean your tool. Watch what you are doing and use common sense. Before further use of the tool, a guard or any other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or any other part that is damaged should be properly repaired or replaced by an authorised service centre. DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF. Have defective switches replaced by authorised service centre. DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL OR ANY MEDICATION. Depress the trigger switch to start the cutting action. Set the base assembly against the workpiece. Use only enough pressure to keep the saw cutting. Keep pressure on the base, against the workpiece. PLUNGE CUTTING Fig 5. See Figure 6. Follow these directions to plunge cut. Secure the workpiece to a work bench or table with a vise or with clamps. Make sure the saw blade is clear of any foreign material and that the power cord and extension cord are out of the blade path. Hold the saw firmly in front of and clearly away from you. Choose a convenient starting point inside the cutting area and place the tip of the blade over that point. Rest the front edge of the shoe assembly on the workpiece and hold it firmly in position during the cut. Depress the trigger switch and allow the saw blade to reach full cutting speed. [. . . ] Should service become necessary during the warranty period, the owner should contact the Authorised Ryobi Retailer from whom the Product was purchased, or the nearest Company Branch Office. In order to obtain guarantee service, the owner must present the sales docket and Guarantee Certificate to confirm date of purchase. This product is sold by the dealer or agent as principal and the dealer has no authority from the Company to give any additional guarantee on the Company's behalf except as herein contained or herein referred to. Guarantee Conditions This guarantee only applies provided that the Product has been used in accordance with the manufacturer's recommendations under normal use and reasonable care (in the opinion of the Company) and such guarantee does not cover damage, malfunction or failure resulting from misuse, neglect, abuse, or used for a purpose for which it was not designed or is not suited and no r e p a i r s , a l t e r a t i o n s o r modifications have been attempted by other than an Authorised Service Agent. [. . . ]