User manual RYOBI 600W IMPACT DRILL EID600RG

[. . . ] Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Keep proper footing and balance at all times. [. . . ] If operating power tools in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. English hands of untrained users. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. SPECIFICATIONS Voltage Chuck capacity Drilling capacity in wood in steel in masonry Input No-load speed Blows per minute Weight 25 mm 13 mm 13 mm 600 W 0 - 2, 700 min-1 0 - 43, 000 min-1 2. 04 kg 240 V 50 Hz 13 mm (1/2") STANDARD ACCESSORIES Auxiliary handle. SPECIAL SAFETY RULES Wear ear protectors. Exposure to noise can cause hearing loss. Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. If operation is dusty, also wear a dust mask. Hold power tool by insulated gripping surfaces when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons. Adequate supervision by a responsible person must be provided to ensure that they do not play with the appliance. Visitors should wear safety glasses and be kept a safe distance from work area. [. . . ] This warns the user that the tool is connected and will operate when the switch is pressed. MAINTENANCE After use, check the tool to make sure that it is in good condition. It is recommended that you take this tool to a RYOBI authorised service center for a thorough cleaning and lubrication at least once a year. Do not make any adjustments while the motor is in motion. Always disconnect the power cord from the power supply before changing removable or consumable parts (blade, bit, etc. ), Lubricating or working on the unit. WARNING To ensure safety and reliability, all repairs should be performed by an authorised service center or other qualified service organisation. [. . . ]