User manual RYOBI 600W JIGSAW EJS600RG

[. . . ] EJS600RG JIGSAW OWNER'S OPERATING MANUAL DESCRIPTION 1. Switch Lock-on button Safety guard Base Degree marks Saw blade Dust port (connect to dust extraction system, not included) Roller guide Slot 10. Blade storage area 2 16 1 13 12 7 18 17 5 4 18 7 6 3 11 8 9 Fig. 5 45° 22. 5° 0° 5 15 8 14 Fig. [. . . ] Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons. Adequate supervision by a responsible person must be provided to ensure that they do not play with the appliance. Visitors should wear safety glasses and be kept a safe distance from work area. Do not let visitors contact tool or extension 2 WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. OPERATION SWITCH See Figure 1. To turn your saw ON, depress the switch. Release trigger switch to turn your saw OFF. Your saw is equipped with a lock-on feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the trigger switch, push in and hold the lock-on button located on the side of English the handle, then release trigger switch. Release lock-on button and your saw will continue running. To release the lock, depress the trigger switch and release. If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, disengage the lock-on feature immediately. Your saw has a variable speed control selector designed to allow operator control and adjustment of speed and power limits. The speed and power of your saw can be increased or decreased by rotating the variable speed control selector in the direction of the arrows. NOTE: Hold your saw in normal operating position and turn the variable speed control selector counterclockwise to increase speed and power. Turn clockwise to decrease speed and power. If you wish to lock the switch on at a given speed, depress the trigger switch, push in and hold the lock-on button, and release the trigger switch. Next, adjust the variable speed control selector until the desired speed is reached. Avoid running your saw at low speeds for extended periods of time. Running at low speeds under constant usage may cause your saw to become overheated. If this occurs, cool your saw by running it without a load and at full speed. [. . . ] This warns the user that the tool is connected and will operate when the switch is pressed. MAINTENANCE GENERAL All other parts represent an important part of the class II insulation system and should be serviced only by a qualified service technician. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents. Use clean cloths to remove dirt, carbon dust, etc. IMPORTANT When cutting metal, keep exposed portion of saw bar clean and free of metal chips by wiping frequently with an oily cloth. [. . . ]