User manual RYOBI 620DR

[. . . ] No. no: 6000-12000 min-1 115 x 229 mm 50Hz 320W 1/2 SHEET SANDER MADE IN CHINA 11 12 11 9 13 Fig. 6 English GENERAL SAFETY RULES This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. 2 SPECIFIC SAFETY INSTRUCTIONS FOR SANDERS n n n Always wear safety goggles and a dust mask when sanding, especially sanding over-head. The machine is not suitable for wet sanding. Do not use sanding paper larger than needed. Extra paper extending beyond the sanding pad can also cause serious lacerations. The dust bag shall be equipped with the tool. To connect dust bag, insert the adapter of dust bag to the dust-collection opening on the rear end of the sander. WARNING Do not throw sanding dust on an open fire because materials in fine particle form may be explosive. If the new sandpaper have a dust hole, then align holes in paper with holes in cushion, then carefully press fuzzy side of sandpaper against cushion as tightly as possible. n INSTALLING NON-ADHESIVE SANDPAPER (9) n n Lifting up the handle (11), and observing the sandpaper clamp (12) be lifting up also. Insert end of new 1/2 sheet sandpaper approximately 1/2 in. (12. 7mm) under the paper clamp. English OPERATION Note: 1/2 in. clamping of sandpaper is necessary for multisheet stacking of paper. n n Release down the handle and apply clamp downward pressure to conform sandpaper to platen. Lifting up another handle on opposite end of sander and insert loose end of sandpaper under clamp also. Fit sandpaper tight against with cushion. Multi-sheet of sandpaper can be installed at one time for convenience. WARNING Unsecured work could be thrown towards the operator causing injury. Hold your sander in front and away from you, keeping it clear of the workpiece. Start your sander by pressing the switch button to "ON" position and letting the motor build to its maximum speed. [. . . ] To empty dust bag: n Unplug your sander. WARNING Failure to unplug your sander could result in accidental starting causing possible serious personal injury. n n n n n Remove the dust bag assembly from the sander. Replace the dust bag assembly on the sander. LIVE TOOL INDICATOR This tool features a live tool indicator (7) which illuminates as soon as the tool is connected to the supply. [. . . ]