User manual RYOBI 700W JIGSAW EJS700RG

[. . . ] EJS700RG JIGSAW OWNER'S OPERATING MANUAL DESCRIPTION Switch Lock-on button Safety guard Base Degree marks Saw blade Dust port (connect to dust extraction system, not included) 8. Transparent guard (only used for straight cutting) 20. LED worklight 14 2 16 1 13 15 7 3 19 5 11 4 17 9 8 25 18 Fig. 12 Important! It is essential that you read the instructions in this manual before operating this machine. [. . . ] The transparent guard is attached by placing it in front of the blade area of the base and snapping it into the tabs on the sides of the saw base. For removal, simply pull the tap of the transparent guard. Make sure the saw is unplugged before installation and removal. NOTE: The transparent guard can only be used for straight cutting. 240 V 680 W 800 - 3000 min-1 21 mm 50 Hz disengage the lock-on feature immediately. WARNING Before connecting your saw to power supply source, always check to be sure it is not in lock-on position (depress and release trigger switch). Failure to do so could result in accidental starting of your saw resulting in possible serious injury. Also, do not lock the trigger on jobs where your saw may need to be stopped suddenly. FEATURES KNOW YOUR SAW Before attempting to use your saw, familiarize yourself with all operating features and safety requirements. ELECTRICAL CONNECTION Your saw has a precision built electric motor. It should be connected only to a power supply of the type specified by its rating plate. Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and overheating. If your tool does not operate when plugged into an outlet, double-check the power supply. WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING Failure to unplug your saw could result in accidental starting causing possible serious injury. Rotate the quick release lever counter-clockwise and hold in position. Insert the saw blade into the groove in the roller guide, making sure the back of the saw blade is properly positioned in the groove. NOTE: Only T-shank saw blades can be used. Push the saw blade into the blade clamp as far as it will go. Install the transparent guard. OPERATION SWITCH See Figure 1. To turn your saw ON, depress the switch. Release trigger switch to turn your saw OFF. Your saw is equipped with a lock-on feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the trigger switch, push in and hold the lock-on button located on the side of the handle, then release trigger switch. [. . . ] Connect the nozzle of the dust collection system to the dust port. An edge guide is available for use with your saw. It can be used for making crosscuts and rip cuts. TO INSTALL: Unplug your saw. MAINTENANCE GENERAL All other parts represent an important part of the class II insulation system and should be serviced only by a qualified service technician. [. . . ]