User manual RYOBI 720R-SERIALS-407104738-AND-UP

[. . . ] 2) Electrical Safety a) Power tool plugs must match the outlet. Do not use any adaptor plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce the risk of electric shock. b) Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. [. . . ] Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. 4) Power tool use and care a) Do not force the power tool. When cutting tight curves, reduce or switch off the pendulum action. The rip fence helps guide cuts along the grain (rip cut). Together with a centre pin, the rip fence can also be used for cuting circles. The electronic speed control wheel is uesd to programme the required saw speed. In this way the speed can be adapted to fit the material being worked. ¡ö Turn the knob forward to increase the speed. ¡ö Turn the knob backwards to decrease the speed. Number 1 being the slowest speed. PENDULUM STROKE ADJUSTMENT (Fig. 5) SPECIFICATIONS Power input: No load speed: Stoke length: Cutting capacity: 570 W 500-3, 000 min 18 mm Aluminium: 15 mm Steel: 8 mm Wood: 65 mm 0°- 45° 2. 00 kg -1 Together with the electronic speed regulation, the pendulum stroke adjustment helps set the best combination of blade speed and aggressiveness needed to achieve a desired cut rate and fineness. The pendulum knob is used to make the adjustment. ¡ö When using a knife blade, the pendulum setting should be 0. ¡ö We recommend the use of appropriate lubricants for cutting metal. ¡ö Use the following table to obtain the best pendulum stroke settings for the particular work to be carried out. TYPE OF MATERIAL Sheet metal Steel Aluminium The saw blade can be inserted directly into a wood surface without first drilling a pilot hole thus eliminating drilling operation. [. . . ] Push the saw blade shank as far back as possible into the saw blade holder. To release, turn both screws one turn anti-clockwise. Disconnect the unit from the power supply. Raise the safety guard and loosen the allen screws on the base plate with the allen key (Fig. 6). Pull the base plate backward and set the desired angular adjustment according to the scale or push the base plate forward for fixed locks at 0°, 15°, 30°, 45°. [. . . ]