User manual RYOBI 765R-SERIALS-502068326-THRU

[. . . ] If you use your saw properly and only for what it is intended, you will enjoy years of safe, reliable service. SAVE THIS MANUAL FOR FUTURE REFERENCE. 6 8 7 20 24 17 18 11 5 19 3 14 13 1 2 4 12 10 9 15 16 21 22 Fig. 25 GENERAL SAFETY PRECAUTIONS WARNING! When using electric tools basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before attempting to operate your product. [. . . ] Never stand or have any parts of your body in line with the path of the saw blade. Keep your hands out of the line of the saw blade. Move the rip fence out of the way when cross cutting. Feed the work into the blade or cutter AGAINST the direction of rotation only. Never use the fence as a cut-off gauge when crosscutting. Never attempt to free a stalled blade without first turning the saw OFF. Turn off the power switch immediately to prevent motor damage. When transporting the machine use only transportation devices and never use guards for handling or transportation. During transportation the upper part of the saw blade should be covered; for example by the guard. Use an extension table for supporting long workpieces during cutting operation. Ensure that polyfoam packaging is removed before use. 5a) Align the 3 holes of rear extension table (24) with 3 M6 x12, flat washer, spring washer and secure the rear extension table(24) to the main table. MOUNT THE RIP FENCE (FIG. 6&7) Loosen the rip fence lock knobs(5) on the sliding block(19), then slide the fence(6) onto the bolt heads and tighten the rip fence lock knobs(5) (Fig. 6) To lock the rip fence(6), slide the rip fence assembly until the indicator is pointing to Page 4 the desired setting. Then press rip fence lock handle (3) downwards (Fig. 7), to lock the fence into position. is locked before ADJUSTMENT OF SAW BLADE (FIG. 8, 9&10) WARNING: · Do not use saw blades which are damaged or deformed. · Use only saw blades recommended by the manufacturer. · Take care that the selection of the saw blade depends on the material to be cut. The Blade(15) has been adjusted at the factory, use a square to check that the blade is at a 90o angle to the table (Fig. 8) If adjustment is needed turn the tilting lock nut (while holding the adjustment in position) to fix the adjustment. Then loosen the indicator fixing screw, set the indicator of the scale(12) on the " 0o" marked then tighten the fixing screw(Fig. 9) After the 90o setting of the blade has been adjusted turn the tilting handle to the 45o (Fig. 10) side and adjust the 45o angle. Turn the adjustment nut so that the blade is on the 45o position and then tighten the lock nut. Live Indicator (FIG. [. . . ] 22&23) Turn stand(21) upright as shown. Insert the cross head screws, spring washers and flat washer to assemble the four legs and cross braces first. 23) leave all bolts finger tight - do not fully tighten until assembly is complete. Remove the lower extension table brace bolts Carefully place table saw on top of stand. [. . . ]