User manual RYOBI 767R-775R

[. . . ] 767R ­ 775R 2-Cycle Gas Trimmer OPERATOR'S MANUAL 767r TrimmerP lus ® FOR QUESTIONS, CALL 1-800-345-8746 in U. S. or 1-800-265-6778 in CANADA www. ryobi. com IMPORTANT MANUAL DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. [. . . ] NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench. Turn the knob counterclockwise to loosen (Fig. Click-Link® Coupler Release Button Knob 180° Edging Hole Fig. 15 CAUTION: The cutting attachment and add-ons with the Click-Link® system are to be used in the primary hole unless stated otherwise in the specific add-ons operator's manual. Using the wrong hole could lead to personal injury, or damage to the unit. For edging with Click-Link® models, lock the release button of the cutting attachment into the 90° edging hole or the 180° edging hole (Fig. 13 14 OPERATING INSTRUCTIONS HOLDING THE TRIMMER WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Before operating the unit, stand in the operating position (Figs. Check for the following: · The operator is wearing eye protection and proper clothing. · The right arm is slightly bent, and the hand is holding the shaft grip. · The left arm is straight, and the hand is holding the handle. · The cutting attachment is parallel to the ground and easily contacts the vegetation to be cut without the operator having to bend over. 18 Each time the head is bumped, about 1 in. (25. 4 mm. ) of trimming line is released. A blade in the cutting attachment shield will cut the line to the proper length if excess line is released. For best results, tap the Bump HeadTM on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult as the cutting line becomes shorter. 16 Model 775r NOTE: Do not rest the Bump HeadTM on the ground. CAUTION: Do not remove or alter the line cutting blade assembly. Excessive line length will make the clutch overheat. [. . . ] The RYOBI Product including any defective part must be returned to an authorized service dealer within the warranty period. The expense of delivering the RYOBI Product to the dealer for warranty work and the expense of returning it back to the owner after repair or replacement will be paid for by the owner. RYOBI's responsibility in respect to claims is limited to making the required repairs or replacements and no claim of breach of warranty shall be cause for cancellation or rescission of the contract of sale of any RYOBI Product. Proof of purchase will be required by the dealer to substantiate any warranty claim. [. . . ]