User manual RYOBI 767RJ

[. . . ] 767rj 2-Cycle Gas Trimmer OPERATOR'S MANUAL FOR QUESTIONS, CALL 1-800-345-8746 in U. S. or 1-800-265-6778 in CANADA www. ryobi. com IMPORTANT MANUAL DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. [. . . ] · The left arm is straight, and the hand is holding the handle. · The cutting attachment is parallel to the ground and easily contacts the vegetation to be cut without the operator having to bend over. Each time the head is bumped, about 1 inch (25. 4 mm. ) of trimming line is released. A blade in the cutting attachment shield will cut the line to the proper length if excess line is released. For best results, tap the Bump HeadTM on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult as the cutting line becomes shorter. NOTE: Do not rest the Bump HeadTM on the ground. CAUTION: Do not remove or alter the line cutting blade assembly. Excessive line length will make the clutch overheat. This may lead to serious personal injury or damage to the unit. Some line breakage will occur from: · Entanglement with foreign matter · Normal line fatigue · Attempting to cut thick, stalky weeds · Forcing the line into objects such as walls or fence posts TIPS FOR BEST TRIMMING RESULTS · Keep the cutting attachment parallel to the ground. · Do not force the cutting attachment. Allow the tip of the line to do the cutting (especially along walls). Cutting with more than the tip will reduce cutting efficiency and may overload the engine. · Cut grass over 8 inches (200 mm. ) by working from top to bottom in small increments to avoid premature line wear or engine drag. Fig. 10 ADJUSTING TRIMMING LINE LENGTH The Bump HeadTM cutting attachment allows you to release trimming line without stopping the engine. To release more line, lightly tap the cutting attachment on the ground (Fig. 11) while operating the trimmer at high speed. NOTE: Always keep the trimming line fully extended. Line release becomes more difficult as cutting line becomes shorter. · Cut from right to left whenever possible. Cutting to the left improves the unit's cutting efficiency. Clippings are thrown away from the operator. [. . . ] Any part of the RYOBI Product manufactured or supplied by RYOBI and found in the reasonable judgement of RYOBI to be defective in material or workmanship will be repaired or replaced by an authorized RYOBI service dealer without charge for parts and labor. The RYOBI Product including any defective part must be returned to an authorized service dealer within the warranty period. The expense of delivering the RYOBI Product to the dealer for warranty work and the expense of returning it back to the owner after repair or replacement will be paid for by the owner. RYOBI's responsibility in respect to claims is limited to making the required repairs or replacements and no claim of breach of warranty shall be cause for cancellation or rescission of the contract of sale of any RYOBI Product. [. . . ]