User manual RYOBI 790R-SERIALS-810046371-THRU-

[. . . ] Battery charging in closed cupboards, near heat sources (radiators, bright sunshine) etc. causes heat to accumulate and can damage the device. n If the battery is not going to be used for a longer period, pull the battery off the battery charger and pull out the mains plug. n Protect battery contact to avoid a short circuit caused by metallic object that can cause a fire or explosion! [. . . ] Damage to property/material Mains voltage must correspond with the voltage specifications on the device. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they do not play with the appliance. Visitors should wear safety glasses and be kept a safe distance from work area. Do not let visitors contact tool or extension cord. Complies with AS/NZS 60335. n n n ASSEMBLY No assembly required on this product. SPECIFICATIONS Battery Pack 130247015 Voltage Charger Input 18 V 18 V Battery No. of cell Capacity for battery 15 10 240V, 50Hz, 1. 7 Ah AC only 240V, 50Hz, 2. 4 Ah AC only 130501002 OPERATION WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. 1 English OPERATION WARNING Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING Do not use any attachments or accessories not recommended by the manufacturer of this product. 2) To display the amount of charge left in the battery, press and hold the battery gauge button. n If the charge indicator light glows green, the battery pack is fully charged. n If it glows yellow, it has a usable charge remaining but will soon require recharging. n If it glows red, the battery requires recharging as indicated by the battery gauge symbols on top of the battery. 2 English OPERATION n Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger. Note: After charging is complete, the green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply. n The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem. n Do not place the charger and battery pack in an area of extreme heat or cold. They will work best at normal room temperature. Note: The charger and battery pack should be placed in a location where the temperature is more than 10°C but less than 38°C. [. . . ] You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. Note: This situation only occurs when continuous use of a tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to "CHARGING A COOL BATTERY PACK" for normal recharging of batteries. [. . . ]