User manual RYOBI 885R-SERIALS401000001-THRU-

[. . . ] Never lay a tool down before its moving parts have come to a complete stop. ACCESSORIES : The use of accessories or attachments other than those recommended in this manual might present a hazard. Voltage No load speed Hammer blows ( Blows per Minute) Impact energy Maximum Drill Capacity: Wood Steel Concrete (hammer drilling) Recommended hammer drilling range Bit Connection type Weight - not incl. WARNING Do not allow familiarity with products to make you careless. [. . . ] Therefore, the switch should always be locked when not in use or carrying at your side. You may use this product for the purposes listed below: Drilling in all types of wood products (lumber, plywood, panelling, composition board, and hard board) Drilling in ceramics, plastics, fiberglass, and laminates Drilling in metals Hammer Drilling in concrete This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. WARNING Always remove battery pack from your drill when you are assembling parts, making adjustments, assembling or removing bits, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. Follow these steps to adjust the auxiliary handle: Loosen the auxiliary handle by turning the knob counterclockwise (12). Follow these steps to adjust the depth gauge rod: Lock the trigger switch by placing the rotation selector in the center position. Ryobi 18 V lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize battery life. Under some operating conditions, these built-in features may cause the battery and the tool it is powering to act differently from nickel-cadmium batteries. During some applications, the battery electronics may signal the battery to shut down, and cause the tool to stop running. to reset the battery and tool , release the trigger and resume normal operation. NOTE: To prevent further shut down of the battery, avoid forcing the tool. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING Do not at any time let brake fluids, gasoline, petroleum based products, penetrating oils, etc. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury. Abusive practices can damage tool as well as workplace. This tool is equipped with an SDS-plus connection system. Clean the bit and grease it with machine grease before inserting it into the chuck (2). pull back the clamp collar (3) and hold it. Push and rotate the dust-free tool into the bit holder as far as it will go. Release the clamp collar to lock the bit. Drilling mode WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. [. . . ] This warranty in no way affects your legal rights concerning defective products. I händelse av felaktig funktion medan garantin är i kraft skall produkten sändas UTAN ATT DEMONTERAS tillsammans med inköpsbeviset till leverantören eller till närmaste servicecenter som auktoriserats av Ryobi. WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. [. . . ]