User manual RYOBI AP1300

[. . . ] (330 mm) Portable Planer Model AP1300 1-3/4 1-1/2 1-1/4 1/4 0 THANK YOU FOR BUYING A RYOBI PORTABLE PLANER. Your new planer has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. CAUTION: Carefully read through this entire operator's manual before using your new planer. [. . . ] Any good grade plywood or chipboard with a 3/4 in. (19 mm) thickness is recommended. 1-3/4 1-1/2 1-1/4 1/4 0 Fig. 5 Page 9 ADJUSTMENTS LEVELING THE TABLE EXTENSIONS See Figure 6. The infeed and outfeed table extensions are attached to the planer. Shipped in a folded, "upright" position, the table extensions must be in the "down" position before planing can begin. For accurate planing, table extensions must be level with the planer table. Note: For optimum performance, always check to make sure the table extensions are level before beginning planing operations. SCREWS TABLE EXTENSION STOP SCREWS 1-3/4 1-1/2 1-1/4 1/4 0 LOCK NUT To Level: I Unplug your planer. WARNING: Failure to unplug your planer could result in accidental starting causing possible serious personal injury. I Place a straight edge or level across both the planer table and table extensions. I If adjustment is necessary, lift table extensions and loosen lock nuts. Adjust stop screws (one on each side) until extension table is level with planer table. I Press down on the table extension to ensure the table extension is properly seated. I Tighten lock nuts securely when adjustments are complete. Note: Four screws attach table extensions to support bars; loosening these screws may aid in leveling table extensions. PLANER TABLE TABLE EXTENSION 1-3/4 1-1/2 1-1/4 1/4 0 STRAIGHT EDGE Fig. 6 CUTTER HEAD ASSEMBLY CUTTER LOCK DEPTH ADJUSTMENT HANDLE BLADE HEIGHT ADJUSTMENT See Figure 7. Raising and lowering the depth adjustment handle controls the depth of cut on your planer. Note: Never adjust blade height with cutter lock in the "locked" position (pushed to the far right). UNLOCK To Raise: I Push cutter lock to the left to unlock cutter head assembly. I Turn the depth adjustment handle clockwise to desired height. I Once cutter head is in desired position, lock cutter head assembly in place by pushing cutter lock handle to the right. 1-3/4 1-1/2 1-1/4 1/4 0 To Lower: I Push cutter lock to the left to unlock cutter head assembly. I Turn the depth adjustment handle counterclockwise to desired height. I Once cutter head assembly is in the desired position, lock cutter head in place by pushing cutter lock handle to the right. Note: Each complete rotation of the handle moves the cutter head assembly 5/64 in. Page 10 LOCK 1-3/4 1-1/2 1-1/4 1/4 0 Fig. [. . . ] Have service performed by Ryobi Authorized Service Center 1. Replace fuse, reset breaker or call Electrician 3. Have service performed by Ryobi Authorized Service Center 4. Have service performed by Ryobi Authorized Service Center 5. [. . . ]