User manual RYOBI B422 SCHEMA ELECTRIC

[. . . ] Be sure to insulate any loose unconnected leads with electrical tape for safety. Notes on the power supply lead (yellow) When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. When no car circuits are rated high enough, connect the unit directly to the battery. The numbers in the list are keyed to those in the instructions. [. . . ] The bracket and the protection collar are attached to the unit before shipping. Before mounting the unit, use the release keys to remove the bracket from the unit. for details , see "Removing the protection collar and the bracket ()" on the reverse side of the sheet. Keep the release keys for future use as they are also necessary if you remove the unit from your car. Caution Handle the bracket carefully to avoid injuring your fingers. Note Before installing, make sure that the catches on both sides of the bracket are bent inwards 2 mm (3/32 in). If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Notes (-A) Be sure to connect the ground (earth) lead before connecting the amplifier. Connecting any other system may damage the unit. If you have a power antenna (aerial) without a relay box, connecting this unit with the supplied power supply lead may damage the antenna (aerial). Front panel release button Taste zum Lösen der Frontplatte Touche de déverrouillage de la façade Tasto rilascio pannello anteriore Toets om het voorpaneel los te maken Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. Before installing the unit, remove the protection collar and the bracket from the unit. Yellow Gelb Jaune Giallo Geel continuous power supply permanente Stromversorgung alimentation continue alimentazione continua continue voeding Red Rot Rouge Rosso Rood Yellow Gelb Jaune Giallo Geel switched power supply geschaltete Stromversorgung alimentation commutée alimentazione commutata geschakelde voeding Pinch both edges of the protection collar , then pull it out. Insert both release keys together between the unit and the bracket until they click. Pull down the bracket , then pull up the unit to separate. Notes Bend these claws outward for a tight fit, if necessary (-2). Make sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). How to detach and attach the front panel Before installing the unit, detach the front panel. [. . . ] Make sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). How to detach and attach the front panel Before installing the unit, detach the front panel. Yellow Gelb Jaune Giallo Geel Yellow Gelb Jaune Giallo Geel switched power supply geschaltete Stromversorgung alimentation commutée alimentazione commutata geschakelde voeding Red Rot Rouge Rosso Rood Yellow Gelb Jaune Giallo Geel continuous power supply permanente Stromversorgung alimentation continue alimentazione continua continue voeding Before detaching the front panel, be sure to press and hold . Press the front panel release button, and pull it off towards you. [. . . ]