User manual RYOBI BD1025R SCHEMA

[. . . ] Do not pull or carry by cord, use cord as a handle, close door on cord or pull cord around sharp edges or corners. Always disconnect cord from electrical outlet before servicing the cleaner. Turn off all controls before unplugging. Never handle plug or appliance with wet hands. [. . . ] snap tabs (A) on float cage into slots (B) on tank. Once in place, do not remove the float assembly. Note: Do not attempt to remove the large filter cage or float ball on cleaner lid. With inner tank duct toward drain side of outer tank, align tab (C) on inner tank with slot (D) in outer tank; slide inner tank into place. With wet/dry selector (F) toward drain side of tank align ribs (G) on front of tank with slots (H) on either side of hose inlets; place lid on tank. Push hose into hose intlet on tank; twist hose to tighten or loosen connection. Press squeegee insert firmly into wet/dry nozzle opening (See Fig. This feature allows the user to change from wet pickup to dry pick-up without having to empty the tank or change filters. dry debris will collect in the inner tank and wet debris will collect in the outer tank. Wear ear protection if operating cleaner for a prolonged period of time. Make sure that the small foam and cartridge filters are in place. The automatic shut-off will function for both separate wet/dry tank and single tank operation. Rinse inside of tank thoroughly with clean water particularly if spills or other liquid substances other than plain water have been picked up. The larger diameter wands fit into outer triangle, the smaller diameter wands store inside the larger wands and over small triangular peg. For best results when picking up dry wall dust, slide wet/dry selector (A) to expose "WET/DRY INLET" and make sure no water or moisture is in the Wet Tank (outer tank). The blower can be used to blow dirt out of areas where it is impossible for suction to reach. Inside of hose and tools must be free of litter before operating blower. Push hose into blower port (C); twist hose to tighten or loosen connection. Attach blower nozzle (included with some models) or other tool if desired. CAUTION Wear safety goggles when using blower feature. Do not blow toward people, animals, or objects that may be damaged by flying debris. Wear ear protection if using the blower for a prolonged period of time. [. . . ] During wet vacuuming, if the float rises and blocks suction, you will notice the change in the sound that the machine makes. This is a safety feature and is intended to prevent continued use when the recovery tank is full of liquid. Switch off the appliance, empty the liquid, reassemble and then restart. *Bij model EWD1245 meegeleverd **Bij model EWD1260 meegeleverd Opmerking: de stofzuiger wordt met één van de afgebeelde accessoiresets (diameter 5, 75 cm of 3, 17 cm) geleverd. [. . . ]