User manual RYOBI BD120VR SCHEMA

[. . . ] This manual has been prepared to provide you with common sense operating instructions and to ensure that you will get maximum satisfaction. To keep your unit in top operating condition, use the maintenance and service procedures in this manual. I. CONTENTS Safety Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 A. Pre-Operational Safety Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . 3 B. [. . . ] The use of non-standard parts, or other accessories or attachments not designed for this unit, could result in serious injury to the user and/or damage to the unit. Never use metal-reinforced line or monofilament line that is not specifically designed for use with your model. This model uses 0. 06 inch (1. 6 mm) monofilament line. STORE UNIT INDOORS - When not in use, the unit should be stored placed on the wall station in the charging mode, which should be located in a cool, dry and high place - out of the reach of children. OPERATIONAL SAFETY WARNINGS 1. To reduce the risk of injury to yourself and others, never operate the unit without the string guard in place. Wear safety glasses or goggles at all times when operating this unit. Use rubber gloves and substantial footwear when working outdoors. Keep hands, face, feet and long hair away from all moving parts. Do not attempt to touch or stop the string while it is rotating. Always hold the unit with both hands during operation. Keep a firm grip on both the front and rear handles or grips. Install and tighten the bolt, washer, and wing nut. Fig. 3 5 INSTALLING THE STRING GUARD 3. Install the screws and washers with a screwdriver (Fig. 6). WARNING Never operate the trimmer without the string guard installed. If the unit is operated without the string guard in place, you will void the warranty. Place the string guard onto the motor assembly. Line up the small tab with the small slot and the large tab with the large slot (Fig. 6 Large Slot Small Tab CHARGING INSTRUCTIONS 1. Make sure the wall station is fastened securely to the wall stud and the charger is plugged into the wall outlet. Large Tab 2. Insert the unit into the wall station and make sure it is firmly seated (Fig. When the red light is on, the battery is being charged (Fig. [. . . ] Take approximately 20 ft (5. 1 m) of new trimming line, insert one end of the line into the hole in the inner reel (Fig. Wind the line, in even and tight layers, onto the reel (Fig. Wind the line in the direction indicated on the inner reel. NOTE: Failure to wind the line in the direction indicated will cause the Bump Head to operate incorrectly. Fig. [. . . ]