User manual RYOBI BD336 SCHEMA

[. . . ] Pay close attention to the Rules for Safe Operation, Warnings, and Cautions. If you use your saw properly and only for what it is intended, you will enjoy years of safe, reliable service. Please fill out and return the Warranty Registration Card so we can be of future service to you. Thank you again for buying Ryobi tools. SAVE THIS MANUAL FOR FUTURE REFERENCE TABLE OF CONTENTS Table Of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Before attempting to use your saw, familiarize yourself with all operating features and safety requirements. CUTTING CAPACITIES When the miter angle (miter table) is set at 0°: Your saw will cut dimensional lumber up to a 2 x 6. When the miter angle (miter table) is set at 45°: Your saw will cut dimensional lumber up to a 2 x 4. WARNING: Do not allow familiarity with your miter saw to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. BLADE WRENCH / STORAGE AREA See Figure 2. One end of the wrench is a phillips screwdriver and the other end is a 1/4 in. Use the hex key end when installing or removing blade and the phillips end when removing or loosening screws. A storage area for the blade wrench is located behind the fence. 14 AMP MOTOR Your saw has a powerful 14 amp motor with sufficient power to handle tough cutting jobs. It is made with all ball bearings, and has externally accessible brushes for ease of servicing. CARRYING HANDLE See Figure 3. For convenience when carrying or transporting your miter saw from one place to another, a carrying handle has been provided on top of the saw arm as shown in figure 3. To transport, turn off and unplug your saw, then lower the saw arm and lock it in the down position. Lock saw arm by depressing the lock pin. Remove the saw from the workbench or workstand. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating. If these accessories were not provided with our saw, they are available from your Ryobi dealer. For the location of a distributor near you, call 1-800-525-2579 in the United States. ELECTRICAL CONNECTION Your saw has a precision built electric motor. It should be connected to a power supply that is 120 volts, 60 Hz, AC only (normal household current). Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If your tool does not operate when plugged into an outlet, double-check the power supply. WARNING: The operation of any saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before starting power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend wide vision safety mask for use over eyeglasses or standard safety glasses with side shields. OPTIONAL ACCESSORIES Optional accessories, provided on some models, are available for use with your saw. They include table extensions, a stop block, work clamp, and dust bag. Table extensions increase the work surface to 36 in. (914 mm) wide, providing support for cutting long workpieces. [. . . ] Make sure curvature of brush matches curvature of motor and that brush moves freely in brush tube. s Make sure brush cap is oriented correctly (straight) and replace. 30 Page 22 TROUBLESHOOTING PROBLEM Saw will not start. CAUSE 1. Have switch replaced by an Authorized Service Center. [. . . ]