User manual RYOBI C358

[. . . ] Abrasive Cut-Off Machine Your cut-off machine has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Thank you for buying a Ryobi product. SAVE THIS MANUAL FOR FUTURE REFERENCE TABLE OF CONTENTS n Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The hole pattern allows it to be moved forward when making cuts in tall or thick stock, such as square stock or tube stock. The hole pattern allows it to be moved back when making cuts in stock that is thin or wide, such as angle stock. TRIGGER LOCK See Figure 4. To prevent unauthorized use of the cut-off machine, we suggest that you disconnect it from the power supply and lock the switch in the off position. To lock the switch, install a padlock (not included) through the hole in the switch trigger. When the lock is installed and locked, the switch is inoperable. Store the padlock key in another location. CARRYING HANDLE For convenience when carrying or transporting the cutoff machine from one place to another, a carrying handle has been provided on top of the machine arm as shown in figure 3. To transport, turn off and unplug the machine, then lower machine arm and lock it in the down position. Use the transport chain to lock machine arm in the down position. LOCK-ON BUTTON CARRYING HANDLE MACHINE ARM SWITCH TRIGGER UPPER WHEEL GUARD PADLOCK TRIGGER LOCK LOWER WHEEL GUARD DEPTH STOP QUICK LOCKRELEASE LEVER 14 in. ABRASIVE WHEEL POWER CORD VISE CRANK HANDLE RUBBER FEET (3) FENCE BOLTS ADJUSTABLE FENCE VISE CLAMP Fig. 3 10 LOOSE PARTS The following items are included with your tool: n Hex Wrench n Operator's Manual n Warranty Registration HEX WRENCH Fig. 4 WARNING: The use of attachments or accessories not listed might be hazardous and could cause serious personal injury. ASSEMBLY UNPACKING This product has been shipped completely assembled. n Carefully lift machine from the carton by the carrying handle and the machine base, and place it on a level work surface. To avoid back injury, lift with your legs, not your back, and get help when needed. n This machine has been shipped with the machine arm secured in the down position. To release the machine arm, push down on the top of the machine arm, and unhook the transport chain. n Inspect the tool carefully to make sure no breakage or damage occurred during shipping. n Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool. n The machine is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to specific procedures explained in this manual. n If any parts are damaged or missing, please call 1-800-525-2579 for assistance. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. [. . . ] Test on a different circuit or without anything else on circuit. Have tool serviced; request voltage check from the power company. Have an electrician replace with a 15 amp fuse or circuit breaker. Have the switch replaced at your nearest authorized service center. [. . . ]