User manual RYOBI CBD1441CRS ACCESSOIRES

[. . . ] 3-4 n Specific Safety Rules. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 n Safety Rules for Charger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 n Symbols. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7 n Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 11 If battery pack is within normal temperature range, the red LED on charger will come on. NOTE: If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check. n Charge the battery pack only with the charger provided. n Make sure the power supply is normal household voltage, 120 volts, 60 Hz, AC only. n Connect the charger to the power supply. n Place the battery pack in the charger aligning raised rib on the battery pack with the groove in the charger. n Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger. n Normally the red LED on charger will come on. This indicates the charger is in fast charging mode. n Red LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode. Refer to page 11, "CHARGING THE BATTERY PACK" for charging instructions. n Place the battery pack in the trimmer. Align the raised rib on the battery pack with the groove inside the trimmer, then slide the battery pack into the trimmer. P110 CHARGER WARNING: Always be sure the switch is in the OFF position before installing the battery pack. Failure to do so could cause accidental starting, leading to serious personal injury. n Make sure the latches on each side of your battery pack snap into place and the battery pack is secured in the trimmer before beginning operation. Fig. 4 DEPRESS LATCHES TO REMOVE BATTERY PACK BATTERY PACK CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installation of the battery pack can cause damage to internal components. LATCH REMOVING THE BATTERY PACK See Figure 5. n Locate the latches on the side of the battery pack and depress them to release the battery pack from the trimmer. n Turn the switch to OFF and remove the battery pack from the trimmer. Fig. 5 12 OPERATION WARNING: Battery tools are always in operating condition. Therefore, switch should always be off and the battery pack removed when not in use or carrying at your side. GRIPPING THE TRIMMER See Figure 6. [. . . ] Periodically check the latch and adjust it when necessary. n Turn the switch to OFF and remove the battery pack from the tool. n Using the adjusting wrench provided, tighten the hex nut by turning it clockwise. n Close the latch and assure the latch is securely tightened by checking the sub-base assembly. [. . . ]