User manual RYOBI CLT-1830 B SCHEMA

[. . . ] Pay close attention to the Rules for Safe Operation, Warnings, and Cautions. If you use your drill properly and only for what it is intended, you will enjoy years of safe, reliable service. Thank you again for buying Ryobi tools. SAVE THIS MANUAL FOR FUTURE REFERENCE LO C K SPECIFICATIONS: 1/16 in. (10 mm) Adjustable Variable Speed/Reversible 120 volts, 60 Hz, AC 3. 0 Amperes 0-1300 RPM 1/3 TABLE OF CONTENTS 1. [. . . ] DRILLING INTO ELECTRICAL WIRING IN WALLS CAN CAUSE DRILL BIT AND CHUCK TO BECOME ELECTRICALLY LIFE. Do not touch the chuck or metal housing when drilling into a wall; grasp only the insulated handle(s) provided on the tool. INSPECT FOR and remove all nails from lumber before drilling. Do not operate tool while under the influence of drugs, alcohol, or any medication. WHEN SERVICING USE ONLY IDENTICAL RYOBI REPLACEMENT PARTS. To reduce the risk of electric shock, this tool has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Review them frequently and use them to instruct others who may use this tool. If you loan someone this tool, loan them these instructions also. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. NOTE: Closing chuck jaws completely without a bit inserted could cause premature failure of the chuck. UNLOCK (RELEASE) KEYLESS CHUCK BODY CHUCK JAWS U NL OCK LO C WARNING: Do not hold chuck body with one hand and use power of the drill to tighten chuck jaws on drill bits. Chuck body could slip in your hand or your hand could slip and come in contact with rotating drill bit. This could cause an accident resulting in serious personal injury. DRILL BIT LOCK (TIGHTEN) KEYLESS CHUCK COLLAR Fig. To turn your drill ON, depress the switch trigger. Release switch trigger to turn your drill OFF. LOCK-ON BUTTON LOCK-ON BUTTON See Figure 3. Your drill is equipped with a "lock-on" feature, which is convenient when continuous drilling for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your drill will continue running. To release the lock, depress the switch trigger and release it. If you have the "lock-on" feature engaged during use and your drill becomes disconnected from power supply, disengage the "lock-on" feature immediately. SWITCH TRIGGER Fig. 3 WARNING: Before connecting your drill to power supply source, always check to be sure it is not in "lock-on" position (depress and release switch trigger). [. . . ] UNPLUG YOUR DRILL. HEX KEY WRENCH (ALLEN WRENCH) KEYLESS CHUCK CHUCK REMOVAL Fig. 9 WARNING: Failure to unplug your drill could result in accidental starting causing serious injury. Insert hex key wrench into chuck and tighten chuck jaws securely. Tap Allen wrench sharply with a mallet in a clockwise direction. [. . . ]