User manual RYOBI CMI-1802

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool'' in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. 1) WORK AREA a) Keep work area clean and well lit. [. . . ] Liquid ejected from the battery may cause irritation or burns. 6) SERVICE a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 7) SPECIAL RULES a) Wear ear protectors with impact drills. Exposure to noise can cause hearing loss. To reduce risk of injury, charge only nickel-cadmium type rechargeable batteries. Other types of batteries may burst, causing personal injury and damage. do not expose charger to wet or damp conditions. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injuries to person. To reduce risk of damage to charger body and cord, pull by charger plug rather than cord when disconnecting charger. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage and stress. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: Model Voltage Chuck (mm) Switch No load speed (drill mode): - Lo speed (min-1) - Hi speed (min-1) No load speed (impact mode): - Lo speed (min-1) - Hi speed (min-1) Max. Battery pack (KG) Battery pack: Charger CMD-1202 12 V 13 Variable speed CMD-1442 14. 4 V 13 Variable speed CMD-1802 18 V 13 Variable speed CMI-1202 12 V 13 Variable speed CMI-1442 14. 4 V 13 Variable speed CMI-1802 18 V 13 Variable speed That pins on plug of extension cord are the same number, size and shape as those of plug on charger. Do not operate charger with a damaged cord or plug. if damaged , have it replaced immediately by a qualified serviceman. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. [. . . ] This tool has the feature of being reversible. the direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. the drilling direction is reversed when the selector is to the right of the switch. [. . . ]