User manual RYOBI CMI1442 SCHEMA

[. . . ] 3-6 Electrical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Glossary of Terms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Unpacking and Tools Needed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Loose Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Note: Arbor shaft has right-hand threads. Check all clearances for free blade rotation. Lower the blade by turning the blade adjustment handle clockwise. 14 NOTE: PLACE BLADE BETWEEN INNER AND OUTER BLADE WASHER SMALL WRENCH LARGE WRENCH ARBOR TO LOOSEN TO INSTALL BLADE GUARD ASSEMBLY Lower the blade by turning the blade adjustment handle clockwise. Using an adjustable wrench, install the blade guard assembly by loosening the two attachment nuts enough to attach the separator (align holes and tabs). Partially retighten the two attachment nuts. Check the blade and separator alignment. Correctly align the blade and separator as shown, repeating above step as needed. If separator is not positioned correctly with blade up, it could contact saw table when blade is lowered and restrict blade elevation. SPACER/ WASHER FLANGE/SPACER FLANGE NUT TO TIGHTEN HOLES Fig. 15 SEPARATOR ATTACHMENT NUTS TABS MOUNTING PLATE DO NOT REMOVE ATTACHMENT NUTS Fig. 16 Page 18 OPERATION BASIC OPERATION OF THE TABLE SAW A table saw can be used for straight-line cutting operations such as cross cutting, ripping, mitering, beveling, and compound cutting. To avoid pinching the blade, support the work properly before beginning a cut. When making a cut, use steady, even pressure. Always hold your workpiece firmly with both hands or with pushsticks. Keep your body in a balanced position to be ready to resist kickback should it occur. Never stand directly in line with the blade. PUSH BLOCKS Fig. 17 WARNING: Never stand directly in line with the blade or allow hands to come closer than 3 in. Failure to heed this warning can result in serious personal injury. CUTTING TIPS Dado and rabbet cuts are non-through cuts which can be either rip cuts or cross cuts. Carefully read and understand all sections of this operator's manual before attempting any operation. WARNING: All blades and dado sets must be rated for at least 5, 500 RPM to prevent possible injury. Page 19 OPERATION FEATHERBOARD A featherboard is a device used to help control the workpiece by guiding it securely against the table or fence. Featherboards are especially useful when ripping small workpieces and for completing non-through cuts. The end is angled, with a number of short kerfs to give a friction hold on the workpiece. Lock it in place on the table with a C-clamp. [. . . ] Your table saw has a convenient storage area specifically designed for holding blades and blade wrenches. Remove the knob and slide the blade and blade wrenches over the bolt. Retighten the knob. MITER FENCE AND RIP FENCE STORAGE See Figure 49. Your table saw has a convenient storage area specifically designed for your miter fence and rip fence. [. . . ]