User manual RYOBI CS1530-1 SCHEMA

[. . . ] Cluttered work areas and work benches invite accidents. DO NOT leave tools or pieces of wood on the saw while operating. The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. [. . . ] Inspect all parts carefully to make sure no breakage or damage occurred during shipping. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. LOOSE PARTS LIST 1. Flat head screws - (4) TOOLS NEEDED Phillips head screwdriver WARNING: If any parts are missing, replace the missing parts before assembling the kit. Failure to do so could result in serious personal injury. 1 3 2 3 ASSEMBLY WARNING: The table saw should never be connected to a power supply when you are assembling or disassembling parts. Disconnecting the table saw will prevent accidental starting that could cause serious personal injury. PREPARING THE ZERO CLEARANCE THROAT PLATE FOR USE WITH A STANDARD BLADE To prepare the zero clearance throat plate for use with a standard blade, cut an opening for the blade guard, install the throat plate, and then make the zero clearance cut. TO CUT AN OPENING FOR THE BLADE GUARD Figures 1 and 2 Follow these directions to cut an opening for the blade guard. Set up the original throat plate and properly install the blade guard assembly on the table saw. Refer to the table saw operator's manual. Position the new throat plate on the saw in front of the blade guard with the crescent-shaped opening to the right. Measure from the rear of the throat plate, and mark lines at 6-1/8 in. Raise the saw blade to a height of 1 in. For the BT3100: Remove the screw at the front of the plate, lift and remove the plate, and then remove the two screws underneath the plate. Raise carefully the anti-kickback fingers on the blade guard assembly. Install the zero clearance throat plate by sliding it under the fingers and surrounding the riving knife (splitter). Make sure the saw blade is in the lowest position. Secure the zero clearance throat plate with the four flat head screws provided. Fig. 3 TO MAKE A ZERO CLEARANCE CUT See Figure 4. Follow these steps to make a zero clearance cut. Choose one of these options: To make a straight zero clearance cut: a) Turn on the saw. b) Rotate the blade adjustment handle clockwise to raise the blade through the throat plate. To make a bevel zero clearance cut: a) Move the rip fence to the right at least 6 in. to provide clearance for the blade guard assembly in the bevel position. [. . . ] Drop a light machine oil in the holes to aid in the operation. Install the new throat plate and secure it with the four flat head screws. Insert the key plate and turn on the saw. Rotate the blade adjustment handle clockwise, cutting the new throat plate until the blade is in the highest desired position. [. . . ]