User manual RYOBI CS1530-2 SCHEMA

[. . . ] Cluttered work areas and work benches invite accidents. DO NOT leave tools or pieces of wood on the saw while operating. The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. [. . . ] The instructions or warnings they give are not substitutes for proper accident prevention measures. SYMBOL MEANING SAFETY ALERT SYMBOL: Indicates danger, warning or caution. May be used in conjunction with other symbols or pictographs. DANGER: Failure to obey a safety warning will result in serious injury to yourself or to others. Always follow the safety precautions to reduce the risk of fire, electric shock and personal injury. WARNING: Failure to obey a safety warning can result in serious injury to yourself or to others. Always follow the safety precautions to reduce the risk of fire, electric shock and personal injury. CAUTION: Failure to obey a safety warning may result in property damage or personal injury to yourself or to others. Always follow the safety precautions to reduce the risk of fire, electric shock and personal injury. NO HANDS: Failure to keep your hands away from the blade will result in serious personal injury. WET CONDITIONS ALERT: Do not expose to rain or use in damp locations. NOTE: Advises you of information or instructions vital to the operation or maintenance of the equipment. The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. 3 4 ASSEMBLY REAR VIEW MITER SLOT TABLE 1/4-20 x 1 in. HEX CAP SCREW PLACE SHIMS AS SHOWN SHIMS WASHER 1/4-20 NUT FRONT VIEW Fig. 4 MITER SLOT TABLE ALIGNING THE MITER SLOT TABLE See Figure 4. Place the miter slot table on the saw as shown in Figure 4. Extend a straight edge across the saw table onto the miter slot table and note any space between the straight edge and the miter slot table. If space exists, place one of the shims under the miter slot table and recheck. Add shims as required between the miter slot table and the saw table to allow the miter slot table to be flush with or slightly lower than the saw table. Repeat the process for the rear of the miter slot table. Recheck in front and rear to assure that the miter slot table is not above the surface of the saw table. [. . . ] Repeat the process for the rear of the miter slot table. Recheck in front and rear to assure that the miter slot table is not above the surface of the saw table. Place mounting bolts with washers through holes in the miter slot table and the saw table frame as shown in Figure 5. Place a nut under the lip of the saw frame on each bolt. [. . . ]