User manual RYOBI D50VSR

[. . . ] (13 mm) Electric Drill - D50VSR DOUBLE INSULATED SPECIFICATIONS: Chuck Capacity Switch Rating Input No Load Speed Horsepower 1/16 in. (13 mm) Adjustable Variable Speed/Reversible 120 volts, 60 Hz, AC 3. 5 Amperes 0-600 RPM 3/8 THANK YOU FOR BUYING A RYOBI DRILL. Your new drill has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. [. . . ] Before attempting to use your drill, familiarize yourself with all operating features and safety requirements. APPLICATIONS (Use only for the purposes listed below) 1. Drilling in ceramics, plastics, fiberglass, and laminates. Using driving accessories, such as driving screws with screwdriver bits. Mixing paints. WARNING: If any parts are missing do not operate your drill until the missing parts are replaced. Failure to do so could result in possible serious injury. AUXILIARY HANDLE "D" SHAPED HANDLE CHUCK TO STORE CHUCK KEY STORAGE VARIABLE SPEED CONTROL SELECTOR SWITCH TRIGGER LOCK-ON BUTTON CHUCK KEY TO REMOVE Fig. 1 ELECTRICAL CONNECTION WARNING: Do not allow familiarity with your drill to make you careless. Remember that a careless fraction of second is sufficient to inflict severe injury. Your drill has a precision built Ryobi electric motor. It should be connected to a power supply that is 120 volts, 60 Hz only. Do not operate this tool on direct current (DC). A voltage drop of more than 10 percent will cause a loss of power and the motor will overheat. If this tool does not operate when plugged into an outlet, double-check the power supply. Page 5 OPERATION SWITCH See Figure 2. To turn your drill ON, depress the switch trigger. Release switch trigger to turn your drill OFF. LOCK-ON BUTTON LOCK-ON BUTTON See Figure 2. Your drill is equipped with a "lock-on" feature, which is convenient when continuous drilling for extended periods of time is required. The speed and torque of your drill can be increased or decreased by rotating the variable speed control selector in the direction of the arrows shown in figure 5. NOTE: Hold your drill in normal operating position and turn the variable speed control selector clockwise to increase the speed and torque of your drill. Turn counterclockwise to decrease the speed and torque of your drill. If you desire to lock the switch on at a given speed, depress the switch trigger, push in and hold the lock-on button, and release the switch trigger. Next, adjust the variable speed control selector until the desired speed is reached. NOTE: If the variable speed control selector is fully turned in the counterclockwise direction (zero setting) your drill may not run. If you desire not to use the variable speed control selector, turn it in the full clockwise direction. This will allow the speed of your drill to be fully controlled by the amount of switch trigger depression. [. . . ] NOTE: The chuck screw has left hand threads. See Figure 11. CHUCK REMOVAL Page 10 Fig. 12 MAINTENANCE WARNING: When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage. [. . . ]