User manual RYOBI DS2000

[. . . ] Battery unlocking button Press the button to remove the battery from the power tool. Charger Remove the battery from the power tool and charge using the original battery charger. Make sure that the charger is connected to a socket whose voltage corresponds to the voltage indicated on the charger identification plate. Never use the tool if its cover or any bolts are missing. [. . . ] the lowest torque is obtained on setting 1. The power tool must be switched off when the screwdriver bit is placed in the screw/nut. You will hear a click when the adjusting ring reaches the selected torque position; you can then let go of the ring (5). Drilling Speed 1: suitable for drilling large holes Speed 2: suitable for drilling small holes. Before changing the drill chuck pull out the battery. Open the drill chuck and unscrew the locking screw (Phillips screw, left-hand thread). Insert the Allen key into the drill chuck and loosen the drill chuck by giving the key a light tap (right-hand thread). Drill/Driver Motor Chuck Capacity Drilling Capacity (in steel/wood) No load speed (low/high) (rpm) Torque Net Weight Impact Drill/Driver Motor Chuck Capacity Drilling Capacity (in steel/wood) (in concrete) No load speed (low/high) (rpm) Impacts per minute Torque Net Weight ST-1200 ST-1201 700 10mm 10mm/20mm 300/0-1000 min-1 24Nm 2. CE DÉCLARATION DE CONFORMITÉ Nous déclarons sous notre propre responsabilité que ce produit est en conformité avec les normes ou documents normalisés suivants : 89/336/EEC, 73/23/EEC, 98/37/EEC, EN50144, EN292, EN55014, EN60335 CE DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. It is essential that you read the instructions in this manual before mounting and operating this machine. (a) Yellow light (b) Red light (c) Green light 2 Battery charging interface Slide in battery Before using this device, read and comply with these operating instructions and the relevant national industrial safety regulations. If you wish to charge two battery packs, allow 15 minutes between charging of the battery packs. There are three lights on the charger: green, red, and yellow. Flashing red light: preliminary charging stage (low voltage) which lasts a maximum of three minutes. Flashing red light and yellow light on: if this lasts a long time, it means the battery pack has a short circuit and needs to be examined by an authorised RYOBI SERVICE CENTRE. To charge a battery pack, always use the charger provided. Make sure that the power supply is normal household voltage, i. Insert the battery pack on the charger then slide it in. If the red light is flashing, this indicates that the battery pack is very run down or hot. If battery pack is hot, the red light should stop flashing and become steady once the battery pack has cooled down. If the battery pack is very run down, the red light should become steady once the voltage has increased, normally within 30 minutes. If after one hour the red light is still flashing, this indicates that the battery pack is defective and should be replaced. [. . . ] Damage caused by improper use, overload or normal wear are excluded from the guarantee. Packaging, worn out devices and accessories should be recycled. Faulty batteries must be recycled in accordance with directive 91/157/EEC. Do not throw batteries away in the household waste, into the fire or water. [. . . ]