User manual RYOBI E3910 NM SCHEMA ELECTRIC

[. . . ] 31 Cleaning the interior and accessories . 61 Sliding the appliance into the installation niche . 65 Attaching the appliance to the installation niche . 75 3 IMPORTANT SAFETY INSTRUCTIONS When using the appliance, follow basic safety precautions, including the following: Read all instructions before installation and use to prevent accidents and machine damage. [. . . ] Use caution when removing. 36 Water filter Exchanging the water filter ^ Push in and rotate the filter cap on the base panel of your appliance counterclockwise 180°, 1. ^ Pull the used filter cartridge out of the appliance, 2. ^ Push the filter cartridge with cap, in a horizontal position, all the way into the opening in the base panel, 5. ^ Rotate the filter cartridge clockwise 180° until the cap is in a horizontal position, 6. The filter change needs to be confirmed before the "filter" indicator will go out. See "Re-setting the filter indicator". ^ Remove the cap from the used filter, 3. ^ Take a new filter cartridge out of the packaging and remove the protective cap. ^ Push the cap onto the new filter cartridge, 4. Whenever you replace the filter, the system must be re-set. This will ensure the indicator light for the next filter change will come on at the right time. 37 Water filter Re-setting the filter indicator ^ While holding down the X button, press the access button "p" once. Keep holding the X button down until the following appears in the display (approx. 5 seconds). The filter indicator still flashes in the display. Flush new cartridge for 3 minutes. CAUTION: To avoid property damage due to water leakage, you MUST read and follow these operating instructions before installation and use of this product. WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. NSF is a registered trademark of NSF International. CUNO is a trademark of 3M Company used under license. All rights reserved. For estimated costs of replacement elements please visit your local appliance dealer or parts distributor. 41 Frequently asked questions With the aid of the following guide minor problems can be corrected without a service call. Repairs should only be carried out by a qualified and trained person in strict accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage and may void the warranty. Problems with temperature Issue The freezer does not get cold. Possible fault Solution The machine is not turned Check whether the appliance is on. Check that the plug is correctly inserted in the power outlet. See "Selecting the correct temperature". The temperature is Select a warmer too low. [. . . ] Extension cords do not guarantee the required safety of the appliance (danger of overheating). If any changes are needed to the household wiring or power supply, this work must be performed by a qualified electrician. 74 RemoteVision Miele's RemoteVision Wi-Fi technology creates a 'virtual link' between your appliance and our monitoring center. If a fault occurs, Miele's client service center will be notified and contact you, or another trusted individual identified on your call roster, in order to gain access to your appliance to fix the problem. For information on set-up and installation of the RemoteVision module see the "Installation" section of this manual. [. . . ]