User manual RYOBI EAG2000RS

[. . . ] $WHQĠLH 8]PDQƯEX 'ơPHVLR 7lKWLV 8SR]RUHQMH It is essential that you read the instructions in this manual before operating this machine. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute. Damaged accessories will normally break apart during this test time. Depending on application, use face shield, safety goggles or safety glasses. [. . . ] Do not position your body in the area where 2 power tool will move if kickback occurs. Kickback will propel the tool in direction opposite to the wheel’s movement at the point of snagging. Use special care when working corners, sharp edges etc. avoid bouncing and snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and cause loss of control or kickback. Do not attach a saw chain woodcarving blade or toothed saw blade. Check that the speed marked on the grinding wheel is equal to or greater than the rated speed of the tool. Ensure that the dimensions of the grinding wheel are compatible with the tool and that the wheel ¿ts the spindle. Grinding wheels must be stored in a dry place. Do not store objects on top of the grinding wheels. Grinding wheels must not be used for any operation other than grinding. Inspect the grinding wheel before use to ensure that it is not chipped or cracked. Chips or cracks can cause the wheels to shatter, resulting in possible serious injury. Ensure that the grinding wheel is correctly mounted and tightened before use and run the tool at noload speed for 30 seconds in a safe position. Stop immediately if there is considerable vibration or if other defects are detected. If this condition occurs, check the tool to determine the cause. Do not use separate reducing bushings or adapters to adapt large hole grinding wheels. Ensure that sparks resulting from use do not create a hazard e. Do not hit people, or ignite Àammable substances. Always use protective safety glasses and ear protectors. Use other personal protective equipment such as gloves, apron and helmet when necessary. Never place the tool on the Àoor or other surfaces while it is running. [. . . ] „ Depress the lock button located on the right side of gear case. „ Using the wrench provided, tighten the clamp nut in a clockwise direction. tOOL-LESS WHEEL GUARD See ¿gure 7 - 8. Release the wheel guard lock lever then turn the tool-less wheel guard to the desired position. [. . . ]