User manual RYOBI EBC 1040

[. . . ] ⷠMake sure there are no branches or stones etc. In the way of the cord or the cutting blade, before starting up the appliance. ⷠUse the unit only in daylight or good artificial light. [. . . ] ⷠThe table (below) shows the correct size to use depending on the cord length and nameplate amperage rating. If in doubt, use the next heavier size Iine gauge. If the electric Keep cord is bystanders at Wear head, damaged Do not Ignition/ Ignition/ least 15 m remove plug operate unit Power Switch Power Switch eye and ear away from protection. Unit during from socket and replace operation. Push the D-handle down onto the boom (Fig. Place the safety guard onto the coupling joint pointing towards the motor as indicated in fig. Fix the safety guard into position with the special lock fig. 5 to prevent the safety guard from rotating. CONNECTING THE CORD To prevent disconnection when you connect the extension cord to the power cord, use the cord hook (Fig. ADJUSTING LINE LENGTH The trimmer has a bump (cutting) head, which releases more trimming line without stopping the motor. When the cord starts to get a bit short, knock the cutting head on the bare ground or on hard ground to make the appliance work at top speed. Repeat the process as often as necessary (Fig. EDGING When edging, let the tip of the trimming line do the work (fig. The cutting head will be at the correct angle by holding it parallel to the ground. [. . . ] MODEL Motor Motor Operating RPM Ignition Switch Drive shaft Cutting head Vibration Level Sound pressure level (no load) Guaranteed sound power level (no load) Measured sound power level (no load) Cutting path diameter Operating weight Trimming line diameter EBC 1040 Electric 7500 - 8500 g/m Control switch 6, 2 mm "Bump Head" reel feeding 3, 65 m/s2 (1000 W) LPAm = 76 dB (A) (1000 W) LWA = 96 dB (A) (1000 W) LWA = 94, 8 dB (A) (1000 W) 400 mm (1000 W) 5, 5 Kg (1000 W) 2, 0 mm (1000 W) Motor stops / will not start 2. Cutting head bound with grass or debris · Cutting head will not turn when throttle is squeezed 1. Push the Bump Knob and pull out 102 mm of line until the line is outside of the cutting head Cutting head will not advance 1. [. . . ]