User manual RYOBI EBS1310VFHG

[. . . ] BELT SANDER SAFETY PRECAUTIONS ■ ■ ■ ■ APPLICATIONS Use only for the purpose listed below: 1. For removal of rust and surface finishing for metal. – ■ ■ ■ ■ Hold the tool firmly with both hands. Keep the cord away from the rotating abrasive belt. [. . . ] Then gently place the tool on the work piece surface. Never exert excessive pressure on the tool. The weight of the tool applies adequate pressure. Excessive pressure will retard the abrasive action, leave an uneven finish and cause extra wear to both the tool and the abrasive belt. Always lift the tool off the work piece before turning the switch off. – CLAMP (Optional accessory) The clamp is designed to stabilize the tool when using it tin the bench configuration. – ■ Place the tool on its side and lift the lever (3) to retract the front roller and release the belt tension (Fig. If the belt tension is not released after lifting the lever, loosen the adjustment knob (9) (Fig. 8) Put the belt sander on the sanding frame and attach four slot into slot holder (14). By turning the adjustment bolt counterclockwise, the sanding frame will down and can be taken out. If turning clockwise, it will raise and the depth will be added. Fine adjustment of the abrasive action is possible by turning the adjustment bolt (13). Be sure that the arrow inside of the belt is pointing in the same direction as that of the tool. – Push the lever down to the original position (Fig. Ensure that your fingers are not trapped. 6) The belt life will be increased by using the tracking adjustment. Turn the tool upside down and hold it firmly with one hand, then start the tool and observe the tracking of the sanding belt. Stop the tool and adjust the tracking of the belt by rotating the tracking knob until the edge of the belt is even with the outer edges of both the front and rear rollers. Check that the belt does not rub against the tool’s frame. MAINTENANCE After use, check the tool to make sure that it is in top condition. It is recommended that you take this tool to a Ryobi Authorized Service Centre for a thorough cleaning and lubrication at least once a year. To ensure safety and reliability, all repair should be performed by an AUTHORIZED SERVICE CENTRE or other QUALIFIED SERVICE ORGANIZATION. [. . . ] This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Contudo, se a ferramenta for usada para aplicações diferentes, com acessórios diferentes ou não for devidamente mantida, a emissão de vibrações pode diferir. Et skøn over niveauet for vibrationseksponering bør også tage højde for de perioder, hvor værktøjet er slukket, eller hvor det er tændt uden faktisk at være i brug. [. . . ]