User manual RYOBI EID1002RE

[. . . ] ACCESSORIES: The use of accessories or attachments other than those recommended in this manual might present a hazard. rEPLACEMENT PARTS: When servicing use only identical replacement parts. WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. [. . . ] make sure that the drill bit is securely mounted. An incorrectly mounted bit is extremely dangerous since it can fly off or break during drilling. Do not wear loose clothing or jewellery, they can be caught in moving parts. Protective gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. hold the tool securely with both hands. If not held securely, accidents or injury may result. Never touch the chuck or metal body parts when drilling walls, floors, or other surfaces covering electrical wiring. hold the tool only by the plastic handle to prevent electric shocks. While operating, the work piece must be securely held with a vice or clamp to prevent it from moving due to the drill rotation. Voltage Chuck capacity Drilling capacity in wood in steel in masonry Input No load speed high low Blows per minute high low Weight Safety class II 110 V - 230 V ~ 50 Hz 13 mm (1/2") 40 mm 13 mm 16 mm 1050 W 0 - 2, 880 min-1 0 - 1, 300 min-1 0 - 46, 080 min-1 0 - 20, 800 min-1 3. This tool is started and stopped by squeezing and releasing the trigger switch (A). The speed can be adjusted in either gear by controlling the force applied to the trigger. The maximum speed of the drill may be set at different speeds by adjusting the variable speed selector (D). For continuous operation, press the lock button (E) while squeezing the trigger. Squeeze the trigger again to release the lock. To change the direction of rotation, stop the tool and push the forward / reverse button (B). When the forward button is pushed in, the bit rotates clockwise when viewed from the handle end of the tool. [. . . ] Loosen the handle grip by turning in direction L, and tighten it at an easy to-use position by turning the grip in direction M. Depth stopper Holes of a fixed depth can be accurately bored by using the depth stopper (G). All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months from the date stated on the original invoice drawn up by the retailer and given to the end user. [. . . ]