User manual RYOBI EJ700L

[. . . ] „ Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the surface leading to possible loss of control and serious injury. „ Hold power tool by insulated gripping surfaces only, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and shock the operator. [. . . ] Scroll cuts can be made with your saw by guiding the direction of the cut with applied pressure on the handle. WARNING Excessive side pressure to the blade could result in broken blades or damage to the material being cut. WARNING Your saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades or when not in use. Disconnecting your saw will prevent accidental starting which could cause serious injury. Rest the front of the saw base on the workpiece and align cutting edge of the blade with the line on your workpiece. Make sure the power cord is out of the way of saw blade and not in the line of cut. Start your saw and move it forward on the work surface. Apply downward pressure to keep the saw steady and only enough forward pressure to keep the blade cutting. aNGLE CUTTING (BEVEL CUTTING) See Figure 7. Bevel cutting angles may be adjusted from 0° to 45° right or left. Angles for cuts from 0° to 45° in 15° increments are marked on a scale on both the left and right side of the base. The use of a protractor is recommended when accurate cuts are required. „ Release the bevel lock lever until the base can be moved. „ Slide base forward slightly to release the base from the tab on the motor housing. „ Align the mark on the base of the desired angle with the edge of the motor housing. „ Once the desired angle is reached, slide the base back until the tab on the motor housing aligns with the appropriate notch on the rear of the base. „ Push the bevel lock lever back to secure the base. NOTE: The transparent guard can only be used for straight cutting. Forcing your saw may overheat the motor and break saw blades. The blade of your saw cuts in orbital motion. This feature is adjustable and provides faster and more ef¿cient cutting. With orbital motion the blade cuts through your work in the upstroke but does not drag across your work in the downstroke. [. . . ] Waste electrical products should not be disposed of with household waste. Check with your Local Authority or retailer for recycling advice. Till ett system INDIKATOR FÖR NÄTANSLUTNING Vinkelslipen är utrustad med en indikator för nätanslutning som tänds då verktyget ansluts till nätet. Følgende retningslinjer må\ følges når det gjelder å fastsette korrekt hastighet for forskjellig bruk: „ LOW hastighet er idéell når minimum hastighet og effekt er ønskelig, for eksempel ved start av skjæringen. [. . . ]