User manual RYOBI EJS710QEO

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool'' in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. May be used in conjunction with other symbols or pictures. [. . . ] If this occurs, cool your saw by running it without a load and at full speed. The following guidelines may be used in determining correct speed for various applications: LOW speed is ideal when minimum speed and power is required, for example starting cuts. mEDIUM speed is suitable for cutting hard metals , plastics and laminates. HIGH speed produces best results when maximum power is required, for example cutting wood. 1) Your saw is equipped with a lock-on (3) feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your saw will continue running. To release the lock, depress the switch trigger and release. If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, disengage the lock-on feature immediately. WARNING Before connecting your saw to power supply source, always check to be sure it is not in lockon position (depress and release switch trigger). Failure to do so could result in accidental starting of your saw resulting in possible serious injury. Also, do not lock the trigger on jobs where your saw may need to be stopped suddenly. 2) Your saw has a variable speed control selector (2) designed to allow operator control and adjustment of speed and power limits. The speed and power of your saw can be increased (R) or decreased (L) by rotating the variable speed control selector in the direction of the arrows. Note: Hold your saw in normal operating position and turn the variable speed control selector counterclockwise to increase speed and power. Turn clockwise to decrease speed and power. If you wish to lock the switch on at a given speed, depress the switch trigger, push in and hold the lock-on button, and release the switch trigger. Next, adjust the variable speed control selector until the desired speed is reached. Note: If the variable speed control selector is fully turned in the clockwise direction (zero setting) your saw may not run. Note: If you desire not to use the variable speed control selector, turn it in the full counterclockwise direction. This will allow the speed of your saw to be controlled by the amount of switch trigger depression. The blade storage area (11) is located on the back of dust port. [. . . ] The chips and grindings from these materials are highly abrasive to electric tool parts such as bearings, brushes, commutators, etc. Consequently, it is not recommended that this tool be used for extended work on any fiberglass material, wallboard or plaster. During any use on these materials it is extremely important that the tool is cleaned frequently by blowing with an air jet. LUBRICATION All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. [. . . ]