User manual RYOBI EMS2025SCL

[. . . ] WARNING: Failure to obey a safety warning can result in serious injury to yourself or to others. Always follow the safety precautions to reduce the risk of fire, electric shock and personal injury. WARNING: Do not attempt to operate this tool until you have read thoroughly and understood completely safety rules, etc. Failure to comply can result in accidents involving fire, electric shock or serious personal injury. [. . . ] If your tool does not operate when plugged into an outlet, double-check the power supply. WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Release switch trigger to turn your saw OFF. Avoid running your saw at low speeds for extended periods of time. Running at low speeds under constant usage may cause your saw to become overheated. If this occurs, cool your saw by running it without a load and at full speed. WARNING Do not insert saw blade (7) into air vents. They could come in contact with electrically live internal parts and cause electric shock, resulting in serious injury. WARNING Your saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades or when not in use. Disconnecting your saw will prevent accidental starting which could cause serious injury. WARNING Failure to unplug your saw could result in accidental starting causing possible serious injury. Insert saw blade as far as possible into slot in saw bar. Check to make sure the back of the saw blade is properly positioned in the groove of the roller guide (12). WARNING To avoid possible serious injury, always wear safety goggles or safety glasses with side shields. Keep hands and fingers away, from the motor housing and blade clamp and do not reach underneath work while blade is cutting. WARNING To avoid serious personal injury, do not use saw without safety guard properly in place. WARNING Excessive side pressure to the blade could result in broken blades or damage to the material being cut. [. . . ] Clamp the work firmly and cut close to the clamping point to eliminate any vibration of the workpiece being cut. When cutting conduit, pipe or angle iron, clamp work in a vise if possible and saw close to the vise. To cut thin sheet materials, "sandwich" the material between hardboard or plywood and clamp the layers to eliminate vibration and material tearing. By doing this, the material will be cut smoothly. [. . . ]