Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual RYOBI EMTP0006. We hope that this RYOBI EMTP0006 user guide will be useful to you.
Lastmanuals help download the user guide RYOBI EMTP0006.
Detailed instructions for use are in the User's Guide.
[. . . ] A single beep will be generated and "ON" will be shown on the LCD after calibration is completed. · Slowly slide the unit horizontally across the wall, right or left. As you begin to approach the stud, the bars on the LCD will light up. · When the word "EDGE" flashes and a continuous beep is heard, mark location as the first edge. [. . . ] Computation range of addition: 9999'11" (999m)
ON/OFF KEY MULTIPLYING KEY
HINTS
· Any large obstacle found within ± 5 degrees of the viewing angle of the unit might be regarded as the target. · Hard surfaces usually give more accurate results. · To measure small, irregular or soft objects, place a piece of cardboard on front of the object. · The unit cannot measure through glass.
SONIC APERTURE
LASER APERTURE
MEASUREMENT PROCEDURES
· The unit functions as a distance measurer with the top edge as Measurement Base the measurement base, and is to be held upside down. The LCD will automatically adapt to this orientation and show reading accordingly. Target · Select the measurement unit. · Point the bottom of the unit perpendicular to the target. The laser will show where the unit is pointing and is "ON" only while reading is being taken. · Caution: Do not stare directly at the laser beam. · Press the "READ" button to take the measurement. · Hold the "READ" button for continuous measurement.
INSTALLING THE BATTERY
· Slide the door off the back of the unit. Place battery in compartment and reinstall door. · Alkaline Battery life is approximately 20 hours. · The battery should be replaced when battery indicator reads low charge.
Situations
No indications.
Possible Causes
· No studs in that area. · You accidently calibrated over a stud.
Solutions
· Move several inches to the left or right and start again.
RYOBI TECHNOLOGIES INC. 1428 Pearman Dairy Road, Anderson, SC 29625 www. ryobitools. com Telephone: 1-800-525-2579
TURNING ON THE UNIT
· Press "Read" or side yellow "On/Off" button on the unit, if LCD screen lights up the power is on.
FEATURES
ex posure to the beam . Read instructions in manual
· Calibration on wall of high density such · Move several inches to the left or tight and start again. · On rough surfaces, place a piece of cardboard on the · Unit not flat against wall. [. . . ] Repeat step one and two for further additions. The result of the addition is shown at the upper row of the LCD. The 1-digit counter records the number of readings added. It's maximum value is 9 and larger number will be displayed as "-".
ON/OFF
WARRANTY
This product is a consumable item. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE RYOBI EMTP0006
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual RYOBI EMTP0006 will begin.
