User manual RYOBI ERH-600VA

[. . . ] Do not force small tools to do the job of heavy-duty tools. Do not use tools for purposes not intended. For example, do not use a circular saw for cutting tree limbs or logs. Do not wear loose clothing or jewellery that can get caught in moving parts. [. . . ] Use a line detector to locate concealed electric, water or gas lines in walls. avoid touching live components or conductors. Wear goggles and use a dust mask on jobs generating dust. Do not use your hammer drill near flammable liquids or gases. Always pull the plug out of the socket before cleaning your tool or changing accessories. Important It is imperative to follow all national safety regulations concerning installation, operation and maintenance of the tool. Voltage Power consumption No Load Speed No load speed in hammer mode Maximum drilling capacity: - steel - concrete / stone Tool Attachment Weight Vibration level Insulation class 230 V / 110 V 50 Hz AC only 600 W 0 - 850 min-1 0 - 4, 400 min-1 10 mm 20 mm SDS-Plus 2. Noise and vibration values measured according to EN 50144. Important To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Before you use your tool, read these instructions carefully and make sure that you understand them thoroughly. Make sure that the voltage (Volts) used corresponds to the voltage marked on the tool's rating plate. When using cable drums, run all the cable off the drum. If incorrectly fitted, chisel bits and drill bits may be flung out of the tool accidentally and cause serious injury. Before you start using your hammer drill, always check that the chisel or drill bit is properly locked in the chuck. examine the chuck regularly for signs of wear or damage. Always press the hammer drill against the work surface (wall, ceiling, etc. When you are finished, unplug the hammer drill from the power supply and remove the chisel or drill bit. Always disconnect the hammer drill from the power supply before you change the chisel or drill bit. Wear safety goggles to protect your eyes from flying particles and splinters. Wear a helmet and put up partition walls in your work place! [. . . ] Unplug the hammer drill before making any adjustment, servicing or cleaning the tool. Never use caustic agents to clean the plastic parts. At the end of your work, to prevent dust deposits you should use compressed air (max. All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months from the date stated on the original invoice drawn up by the retailer and given to the end user. [. . . ]