User manual RYOBI ERO2412VHG

[. . . ] WARNING Do not throw sanding dust on an open fire because materials in fine particle form may be explosive. WARNING A suitable breathing respirator must be worn while sanding lead paint, some woods and metal to avoid breathing the harmful/toxic dust or air. APPLICATIONS Use only for the purposes listed below: Q Q Q Sanding on wood surfaces. ON/OFF Switch Quick Change Hook & Loop Pad Sandpaper Variable Speed Control Dust bag frame Dust bag Livetool indicator SYMBOL The following show the symbols used for the tool. [. . . ] uSING THE DUST BAG ASSEMBLY The dust bag assembly provides a dust collection system for the sander. Sanding dust is drawn up through the holes of the sanding disc and collected in the dust bag during sanding. 3) Follow these directions to attach the dust bag assembly. 1) WARNING Unsecured work could be thrown towards the operator causing injury. Hold your sander in front and away from you, keeping it clear of the workpiece. Start your sander by pressing the switch button to "ON" position and letting the motor build to its maximum speed. Gradually lower your sander on the work with a slight forward movement. Move it slowly using forward and backward strokes. WARNING Failure to unplug the tool could result in accidental starting causing possible serious injury. Q Slide the dust bag assembly onto the blower exhaust on the sander using a slight twisting motion. 4) For more efficient operation, empty the dust bag when it is no more than half full. This will permit the air to flow through the bag better. Always empty and clean the dust bag thoroughly upon completion of a sanding operation and before placing the sander in storage. To empty dust bag: Q WARNING Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc. They contain chemicals that can damage, weaken, or destroy plastic. Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air. WARNING Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. WARNING Failure to unplug your sander could result in accidental starting causing possible serious personal injury. Q Q Q Q Q Remove the dust bag assembly from the sander. Replace the dust bag assembly on the sander. [. . . ] I händelse av felaktig funktion medan garantin är i kraft skall produkten sändas UTAN ATT DEMONTERAS tillsammans med inköpsbeviset till leverantören eller till närmaste servicecenter som auktoriserats av Ryobi. 13 8:49:58 AM GB WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. [. . . ]