User manual RYOBI ETS-1526

[. . . ] When using electric tools basic safety precautions should always be followed to reduce the risk of reduce, electric shock and personal injury. Read all these instructions before attempting to operate your product. Save these instructions for future reference. cluttered benches and dark areas invite accidents. [. . . ] During transportation the upper part of the saw blade should be covered. Use the extension table for supporting long workpieces during cutting operation. ensure that polyfoam packaging is removed before use. Ensure that yellow warning label is removed from table before use. A: Support arm (6pcs) B: Rip fence assembly C: Leg stand (4pcs) D: Blade guard assembly E: Left extension table F: Right extension table G: Mitre gauge assembly H: Rear extension table I: Cross Brace (4pcs) J: Blister pack with screws K: Push stick Input voltage Watts Blade diameter Bore size No load speed Depth of cut at 90O Depth of cut at 45O Main table size Left/Right Extension table sizes Sound pressure level Net weight 230 V ~ 50 Hz 1500W 254mm 30mm 4500min-1 80mm 55mm 638mm x 430mm 638mm x 150mm (x2) 99dB(A) 23. When the noise level exceeds 85 dB (A) be sure to wear ear protection. This machine is designed to rip and cross cut wood exclusively up to maximum thickness of 80mm. For correct operation it must be fixed and operated as explained in this manual. DO NOT cut timber greater than 80mm DO NOT cut metal, stone, rubber, plastic bones, etc. DO NOT modify the machine or its guards/controls DO NOT run the machine before removing all packaging. DO NOT use the saw for slotting (stopped groove). Mount the evaluating handle(13) on the shaft on the left hand size of the saw and fix it by tightening the set screw in the handle (fig 1). Remove the table insert (17) by removing the eight Philips flat head screws. Turn the elevating handle (13) (Fig 1) in the counterclockwise direction to raise the blade shaft to its highest position (Fig 3). Remove the blade fixing nut by turning in a counterclockwise direction, then pull the outer flange form the shaft and the outer arbor. Mount the blade (15) (be sure that the teeth are facing downwards at the front side of the saw. Check again that the blade is (15) securely tightened and re-fit or adjust riving knife as necessary, before remounting the table insert (17). If in place, remove the table insert (17) by removing the eight Philips flat head screws. Insert the riving knife(20), so that the long slots in the riving knife fit around the hexagon socket head end screws(Fig 4). Adjust the riving knjfe(20) so that the clearance between riving knife(20) and blade (15) is between 2 to 5 mm (Fig. 5), then tighten and hexagon socket headed screws. Check to ensure the riving knife (20) and saw blade (15) is in line, Then check again that the blade is securely tightened and remount the table insert. [. . . ] Follow the same procedures as you would for crosscutting. Bevel crosscutting is similar to crosscutting except that the wood is cut at an angle other than the 90° with the flat side of the wood or table (fig. The cut is made at an angle other than 90° to both the edge and the flat side of the wood. Adjust the mitre gauge (9) and the blade (15) to the desired angle and ensure the mitre gauge (9) is locked by using the mitre gauge lock(10). [. . . ]