User manual RYOBI EWS1150RS

[. . . ] ρ Maintain a firm grip with both hands on the saw and position your arms to resist kickback forces. Position your body to either side of the blade, but not in line with the blade. Kickback could cause the saw to jump backwards, but kickback forces can be controlled by the operator, if proper precautions are taken. ρ When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. [. . . ] 2 mm STANDARD ACCESSORIES  Saw blade  Parallel fence  Wrench ASSEMBLY Be sure to disconnect the tool from the power supply before attaching or removing the saw blade. Be sure that the teeth of the saw blade are pointing upward at the front of the tool INTENDED USE Sawing wood. Don’t use it for a purpose not intended. Turn the hex-head bolt with a wrench until the spindle locks. Loosen the hex-head bolt by turning the wrench anticlockwise. Remove the hex-head bolt and the outer blade washer. Retract the lower guard back with the lower guard lever as far as possible under the upper guard. Attach the saw blade against the inner blade washer on the spindle. Fit the outer blade washer and the hex-head bolt. Tighten the hex-head bolt by turning the wrench clockwise. After tightening the hex-head bolt, release the spindle lock button. NOTE: When the blade has been installed, make sure the spindle lock has been released by spinning the blade freely. 2 SPECIFICATIONS Voltage Input No-load speed Bore size Blade size 230 V - 240 V 1150 W 5600 RPM 20 mm 170 mm 50 Hz EN FR DE ES IT NL PT DA SV FI NO RU PL CS HU RO LV LT ET HR SL SK EL TR English REMOVING THE BLADE 1. Turn the hex-head bolt with a wrench until the spindle locks. Loosen the hex-head bolt by turning the wrench anticlockwise. Remove the hex-head bolt and the outer blade washer. Retract the lower guard back as far as possible under the upper guard. Slide the base plate to the desired depth using the depth adjustment knob and then retighten securely. NOTE: The depth of cut can be determined by the depth scale or by measuring the distance by which the blade protrudes from the base plate. Set the cutting angle to any position between 0° and 45°. Loosen the bevel adjustment knob at the front of the tool and move the base plate to the desired angle using the bevel scale. This tool is started and stopped by squeezing and releasing the trigger switch. [. . . ] Blad som ikke er skjerpet eller som er dårlig montert vil lage et tynnere sagspor som vil forårsake for stor friksjon av bladet og dermed en større fare for vridning og tilbakekast. Set the cutting angle to any position between 0° and 45°. Be sure that the teeth of the saw blade are pointing upward at the front of the tool PRZEZNACZENIE Cięcie drewna. Lamele care nu sunt ascuţite sau sunt montate necorespunzător vor produce un traseu de tăiere care va duce la o frecare excesivă a lamei şi deci la riscuri mai mari de îndoire sau de recul. [. . . ]