User manual RYOBI G1251AI SCHEMA ELECTRIC

[. . . ] Use the appliance only for its intended purpose. , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Use this appliance only in the manner intended by the manufacturer. appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. properly installed and grounded by a qualified technician. [. . . ] Press once = 5 minute delay (left indicator lights) Press twice = 15 minute delay (right indicator lights) To cancel the feature press the Delayed Shut Down button again. The fan will not turn off automatically. ^ To save the setting press the "Delay Shut Down" button. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. Turning off the fan ^ Press the On/Off button to turn the fan off. The indicator goes out. 11 Operation Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. Safety cut-out feature If the exhaust hood is left unattended for more than 10 hours, the fan is automatically turned off. The lighting remains on. ^ Press the light button briefly to turn on the lighting. The light button indicator illuminates and the lighting comes on at maximum brightness. ^ Press the light button briefly again to turn off the lighting. ^ To turn the fan back on again, press the On/Off button. Dimming the lighting The brightness of the lighting can be adjusted. ^ While the lighting is turned on, press and hold the light button. The lighting will dim until the button is released. Do not use a stainless steel cleaner on these controls. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. Only use a slightly damp sponge when cleaning the controls. Water could penetrate into the electronics and cause damage. 16 Cleaning and Care Grease filter The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). Removing the grease filter The grease filter should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. , A dirty filter is a fire hazard. To remove the grease filter pull the locking clip forward. Lower the filter 45° unhook it at the rear and take it out. Support the grease filter so that it does not fall onto the cooktop. 17 Cleaning and Care Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. In a Miele dishwasher use the "Normal" program Use the recommended amount of dishwasher detergent. Depending on the detergent, cleaning the grease filter in a dishwasher may cause permanent discoloration of the filter surface. [. . . ] To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl spaces or garages. To reduce the risk of fire, only use metal ductwork. Please read and follow the "IMPORTANT SAFETY INSTRUCTIONS" to reduce the risk of personal injury. [. . . ]