User manual RYOBI G1500 SCHEMA ELECTRIC

[. . . ] 32 General problems with the dishwasher . 43 Cleaning the drain pump and non-return valve . 52 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Use the dishwasher only for its intended purpose. [. . . ] ^ Start the program by closing the door. 27 Program Guide Program guide When to use Pre-rinse 1 2 Program sequence Main wash X Interim rinse 1 2 Final Drying rinse X X Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended. Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware. For normally soiled dishware, energy saving program with a long soaking time and a low temperature To sanitize dishware, e. g. baby bottles, cutting boards and preparation dishware. "Quick program" for lightly soiled dishware, e. g. party dishware or to remove salt traces from the wash cabinet after refilling salt, not suitable for detergent tabs. To rinse dishes when a complete program is not needed. X Normal as required X X X X Economy X X X X SaniWash X X X X Express X X X X Rinse & Hold X Usage: Electrical - 0. 01 - 1. 23 kWh Water - 1. 3 - 6. 3 gal (5 - 24 l) 28 Additional options Buzzer A signal sounds at the end of a program and when a fault occurs. The buzzer at the end of a program sounds five times in quick succession for up to one hour. The buzzer for a fault sounds continuously for up to two minutes. It can be turned off, so it does not sound at the end of a program. The buzzer for a fault cannot be turned off. ­ Contact Miele Technical Service. The drain pump is running when the door is opened. The waterproof system has activated. 31 Frequently asked questions Problems with water Intake / Drain Problem Shortly after the program start the dishwasher stops running. The Intake / Drain indicator flashes when the door is open. The "Intake / Drain" indicator flashes when the door is open. Possible fault The water supply is shut off. Solution ­ Open the water supply. Before fixing the fault: ­ Turn the dishwasher off "o". ­ Open the water supply all the way. ­ Clean the water intake filter, see "User Maintenance Instructions". ­ The water pressure at the water connection is lower than 4. 35 psi. ­ Clean the drain pump and the non-return valve. See "User Maintenance Instructions" for more info on the above. ­ Remove any kinks in the drain hose. Fault in the water drain. [. . . ] ­ If the water pressure if lower, a "Water Intake" notification will be shown. See "Frequently Asked Questions" for more information. ­ If the water pressure is higher than shown, a pressure reducing valve must be used. Ensure that the water connection is secure after the first use. , Installation, repairs and other dishwasher! , Do not drink water from the ­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]