User manual RYOBI HC31 SCHEMA ELECTRIC

[. . . ] 21 Removing the storage shelf from above the drawer . 24 Cleaning the interior and accessories . 38 Adjusting the door opening angle (optional accessory) . 45 Sliding the appliance into the installation space . [. . . ] Possible fault Select a warmer temperature. The door is not closed. A large amount of food is This makes the compressor put in the refrigerator at run longer, causing the the same time. temperature to fall automatically. 29 Frequently asked questions Issue The compressor kicks on very frequently and for too long. Possible fault The ventilation slits are covered or dusty. The door has been opened too frequently, or a large amount of fresh food has been put in at once. Possible fault Solution Clean with a vacuum or brush. Once the fridge gets down to the set temperature the compressor will turn off. Check that the door has been closed properly. Solution The appliance door has Close the door. Possible fault Solution Once the alarm condition has been corrected, the alarm will turn off and the "alarm" indicator will stop flashing. Issue The alarm is ringing and The door is not closed. the "alarm" indicator is A large amount of food flashing. Please contact your local recycling center about the possibility of recycling these materials. Before discarding an old appliance, disconnect it from the electrical supply and cut off the power cord to prevent it from becoming a hazard. 34 Installation Installation site Have the appliance installed by a qualified technician, according to the enclosed installation instructions. The appliance should be installed in a dry, well-ventilated room. Do not install the appliance: - outdoors - in an environment with dripping water - in rooms that are at risk of frost. The installation location should not be exposed to direct sunlight, nor near a heat source, such as an oven, radiator, etc. The ambient temperature should not drop below 55°F (13°C) or rise above 110°F (43°C), otherwise malfunctions may occur. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances from the heat source: ­ 1 1/4" (3 cm) from an electric cooktop or oven. ­ 12" (30 cm) from a gas cooktop or oven. , WARNING This appliance is top-heavy and must be secured to prevent it from tipping forward. Keep the door closed until the appliance is completely installed and secured as per the installation instructions. Empty weight of your machine: K 18X1 Vi . 452 lbs (205 kg) 35 Installation Base A fully loaded appliance is very heavy. [. . . ] If any changes are needed to the household wiring or power supply, this work must be performed by a qualified electrician. 59 RemoteVision (optional accessory) Miele's RemoteVision Wi-Fi technology creates a 'virtual link' between your appliance and our monitoring center. If a fault occurs, Miele's client service center will be notified and contact you, or another trusted individual identified on your call roster, in order to gain access to your appliance to fix the problem. For information on set-up and installation of the RemoteVision module see the "Installation" section of this manual. Be sure your wireless system meets the following requirements ­ A wireless router that supports an IEEE 802. 11b protocol ­ Windows XP® or newer operating system, Mac® OS X 10. 3 or higher ­ Cable or DSL modem ­ Microsoft® Internet Explorer 6 or higher, Safari 2. 0 or higher, Firefox 1. 5 or higher * Please note that each wireless router manufacturer supplies their own device drivers and setup programs. [. . . ]