User manual RYOBI HD501

[. . . ] (13 mm) Hammer Drill DOUBLE INSULATED SPECIFICATIONS: Chuck Capacity Rating No Load Speed Hammer Speed Switch 1/16 in. (13 mm) 120 volts, 60Hz, AC only, 5. 5 Amperes 0 - 1, 000 & 0 - 3, 000 RPM 0 - 48, 000 BPM Adjustable Variable Speed/Reversible THANK YOU FOR BUYING A RYOBI HAMMER DRILL. Your new hammer drill has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. [. . . ] 1 Page 7 OPERATION SWITCH See Figure 2. To turn your hammer drill ON, depress the switch trigger. Release switch trigger to turn your hammer drill OFF. LOCK-ON BUTTON See Figure 2. Your hammer drill is equipped with a "lock-on" feature, which is convenient when continuous drilling for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your drill will continue running. To release the lock, depress the switch trigger and release it. If you have the "lock-on" feature engaged during use and your drill becomes disconnected from power supply, disengage the "lock-on" feature immediately. LOCK-ON BUTTON SWITCH TRIGGER WARNING: Before connecting your hammer drill to power supply source, always check to be sure it is not in "lock-on" position (depress and release switch trigger). Failure to do so could result in accidental starting of your drill resulting in possible serious injury. Also, do not lock the trigger on jobs where your drill may need to be stopped suddenly. Fig. 2 FORWARD FORWARD-REVERSE LEVER REVERSIBLE See Figure 3. Your hammer drill has the feature of being reversible in the drill mode. The direction of chuck rotation is controlled by a lever located above the switch trigger. With your drill held in normal operating position, the direction of rotation lever should be positioned to the left of the switch for drilling operation. The direction of rotation is reversed when the lever is to the right of the switch. The design of the switch will not permit changing the direction of rotation while the drill is running. Release the switch trigger and allow the drill to stop before changing its direction. NOTE: Your hammer drill will not run unless switch lever is pushed fully to the left or right. REVERSE Fig. 3 TO REMOVE TO STORE CAUTION: Your hammer drill has not been designed for reverse hammering. Failure to obey this warning may result in property damage. CHUCK KEY See Figure 4. A chuck key has been provided for use when installing or removing bits. It is also used when removing the chuck. [. . . ] Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc. They contain chemicals that can damage, weaken, or destroy plastic. WARNING: Check extension cords before each use. [. . . ]