User manual RYOBI HT618

[. . . ] NOTE The figures stated above are emission values which do not exactly correspond to the actual sound level in the workplace. While there is a correlation between emission levels and noise nuisance levels, we cannot be sure whether or not additional precautionary measures are necessary. Among the factors which affect existing noise levels in the workplace are the work area itself and the other sources of noise such as the number of machines and the number of jobs being carried out in the surroundings. The authorised sound levels in the workplace can also vary from one country to another. [. . . ] The table saw must be earthed in compliance with applicable standards. Damaged cables and plugs must be replaced immediately by an electrician. The various safety devices must not be removed. All damaged parts/systems must be replaced immediately with genuine spare parts/systems. Workpieces with a tendency to tip or twist must be handled with due care. When the distance between the sawblade and the rip guide is less than 120 mm, you must use a push stick to move the workpiece through the machine. Do not use the machine without a riving knife or an anti-kickback device. Never slow down the sawblade by exerting side pressure. the operator must never face the blade. If you are working in an enclosed space, your machine must be connected to a sawdust extraction device (air speed: min. of 20 m/s in the saw extraction outlet). 8 mm on a tangential axis in relation to the blade), carefully tighten the central screw (Fig. You must loosen the two hexagonal screws (Fig. Once the adjustments have been made, carefully tighten both hexagonal screws (Fig. To adjust the height of the sawblade, you must turn the wheel · to the right to increase cutting height · To the left to decrease cutting height A single turn of the wheel corresponds to an increase or decrease of 2 mm in cutting height. turn the handle to select the tilt of the blade. Once the adjustment has been made, carefully tighten the locking lever. However, should it be necessary to make a few adjustments, loosen screw "c" then move angle limiter "d". The tilt angle can be increased in both directions. By moving angle limiter "d" upwards, you can adjust the tilt angle from ­1. Always disconnect the power plug before replacing the sawblade!Put the stick through the bore hole of the motor spindle. [. . . ] You can now put the saw on its feet and check that the machine is stable. Mount the table extension by attaching the cross pieces to the back of the table. Check that the extension is properly aligned with the table (use the upper screw of the short cross piece to attach the extension arms). Now mount the mitre guide plate and adjust its height. [. . . ]