User manual RYOBI IDC110

[. . . ] Read the user's manual carefully for complete safety, assembly, operating, maintenance and repair instructions. MEANING NO-HANDS SYMBOL Keep your hands away from the blade to avoid all risks of serious personal injury. READ THE USER'S MANUAL Please read the user's manual before starting or operating this machine. Follow operating instructions and safety precautions in this manual. [. . . ] Fuses may "blow" and circuit breakers may trip frequently if: a. THE MOTOR IS OVERLOADED-Overloading can occur if you feed in the workpiece too rapidly, or if there are too many saw accelerations / releases in a short period of time. Voltages within ± 10% of the voltage stated on the dataplate can handle normal loads. For heavy loads, however, the voltage may be insufficient for the motor to operate (because of too small a wire in the supply circuit or an overly long supply circuit wire). Always check the connections, the load and the supply circuit whenever the motor does not run properly. Numerous motor problems are caused by loose or incorrect connections, overload, insufficient voltage (due to small size wire in the supply circuit) or overly long supply circuit cables. Always check the connections, the load and the supply circuit whenever the motor doesn't run properly. 1 Wire sizes The use of extension cables will cause some loss of power. To keep this to a minimum and to prevent overheating and motor damage, use the table below to determine the minimum wire size (lead cross-section) of an extension cable. For circuits that are more than 40 m away from the electrical service box, the thickness of the wire should be increased proportionately in order to deliver sufficient voltage to the saw motor. Handle latch The mitre saw can be locked in the lowered position for compact storage. Secure the saw in the desired location on a work bench. Place the saw in the desired location on a work bench. the base of the saw has four holes for mounting purposes. If the saw is to be used in one location, fasten it to the work bench. WARNING To avoid accidents caused by unintentional starting or electrical shock, do not plug the saw in until all assembly and alignment steps are complete. The power cable must remain unplugged whenever you are working on the saw. NOTE: For compact shipment, the lower blade guard has been removed. The mitre saw is equipped with a handle latch, used to lock the mitre saw in the lowered position. To change the position of the saw, push the handle down slightly and pull the handle latch upwards. Release the handle latch and raise the saw to its upper position. Remove screw 3 and spacer from lower guard. [. . . ] If you do not position the workpiece correctly or if you try to cut the workpiece without the support of the fence, the workpiece will get pinched by the blade. The workpiece could suddenly jump or move and your hand could hit the blade. The supports should be placed along the workpiece so the workpiece does not sag. Your hand holding the workpiece must be 10 cm or more from the blade path. [. . . ]