User manual RYOBI IDC160

[. . . ] Disconnect the product from the power supply when it is not in use, before servicing and when changing accessories. Be familiar with the controls and proper use of the product. Remove all objects, such as rocks, broken glass, nails, wire or string that can be thrown or become entangled in the cutting line. Wear heavy, long pants, boots and gloves. [. . . ] check the product regularly to make sure that it will operate properly and perform the intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts and any other condition that may affect the unit operation. inspect the unit's power connection. Any part that is damaged should be properly repaired or replaced by a Ryobi authorized service centre. Keep the product clean of grass clippings and other materials that may become lodged in the cutting lines and air vents. Never douse or squirt the product with water or 10 Stop the motor when you are waiting to cut or when you are walking from one cutting location to another. Store the product inside in a dry place. Store the product up high or lock it up to prevent unauthorized use or damage. Keep the product out of the reach of children. Refer to them frequently and use them to instruct others who may use this product. If you loan someone this product, loan these instructions also. Main handle Lock-off button Trigger Palm handle Electric power cord Live power indicator Crutch handle (RLT3725CH-A only) Height adjustment button Lower shaft Upper shaft Steel wire guide Rotating release Motor housing Foot pedal (RLT3725CH-A only) Safety guard Spool Bump button Nylon line Bump head Cut-off blade The line trimmer is supplied with some components not assembled. By clutching the upper part of the line trimmer under your right arm and with your left hand holding the lower shaft (9), carefully position the upper shaft (10) over the lower shaft. With your right thumb, push forward the height adjustment button (8) then gradually lower the upper shaft over the lower shaft. Turn/rotate the upper shaft as necessary to ensure it goes onto the lower shaft in the correct orientation. As you insert the upper part over the lower part, take care not to damage the cable and that the cable resides comfortably without strain inside the shafts. Note: There is a paper tag on the shaft to help explain this assembly. Remove this tag once the assembly is complete. It is not possible to disconnect the tubes once they have been assembled/ fixed. Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position. Place the bolt through the front handle as shown, then install the wing nut. Put the crutch handle (7) onto the end of the main handle (1). [. . . ] To switch off the line trimmer, simply release the trigger. CAUTION After switching off, the nylon line will continue to rotate for a few more seconds. Monofilament cutting line could cause serious personal injury or damage to the trimmer. WARNING Make sure the trimmer head stops rotating when you release the trigger. [. . . ]