User manual RYOBI IDC300VM

[. . . ] The safety symbols, and their explanations, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures. CAUTION: Failure to obey a safety warning may result in property damage or personal injury to yourself or to others. [. . . ] Clean after each use, see Cleaning and Storage instructions. This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. May be used in conjunction with other symbols or pictographs. â· WARNING - READ OPERATOR'S MANUAL Read the Operator's Manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders. â· WEAR EYE AND HEARING PROTECTION WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. Wear eye protection and ear protection when operating this unit. â· KEEP BYSTANDERS AWAY WARNING: Keep all bystanders, especially children and pets, at least 15 meters (50 ft. UNLEADED FUEL Always use clean, fresh unleaded fuel. Never point the blower at yourself or others. Old and/or improperly mixed fuel are usually the main reasons for the unit not running properly. Be sure to use fresh, clean fuel and follow the instructions carefully for the proper fuel/oil mixture. Use a high quality synthetic oil formulated for use in 2cycle, WARNING: petrol (gasoline) is extremely flammable and its vapors can explode if they are ignited. Always stop the engine and allow it to cool before filling the fuel tank. Keep sparks and open flames away from the area. Of 2 cycle engine synthetic oil in a separate fuel can, (50:1 = 2%). Do not mix them directly in the engine fuel tank. Always use clean, fresh, unleaded petrol (gasoline) that is less than 60 days old. WARNING: To avoid serious personal injury, always remove the vacuum bag prior to refueling the unit. The bag may become a fire hazard when saturated with fuel. NOTE: Have the shoulder harness on and adjusted, but not clipped to the support fitting prior to starting unit. [. . . ] NOTE: Never use the unit with the lever in the halfway position. While pressing the latching tabs on both sides of the vacuum bag tube, pull the vacuum bag off the unit (Fig. Place the shoulder harness over your head and onto your shoulder and adjust properly, see Installing and Adjusting the Shoulder Harness, Pg. Hold the vacuum, tilting the blower/vacuum tube slightly, and use a sweeping action to collect light debris (Fig. [. . . ]